BAFANG 750W Mid Drive Kit, BBS03 BBS02 1000W 750W 500W Ebike Conversion Motor Kits with LCD Display Electric Bike Conversion Kit

The majority of the install was pretty simple. Plenty YouTube videos to follow. My complaint is the kit I purchased says it fits the 73mm tube. While it does technically fit, I would not say very well. Installing into a 73mm tube leaves few teeth for the final cap to grab on to when installing. But my biggest complaint is that the right side pedal crank is spaced properly from the lower bike frame arm. However the left crank misses the lower frame arm by about 1/8th of an inch. This gets on my OCD's nerves..... Apart from that, it pushes my fat @ss around (750 motor) no problem. I purchased a 20 amp hour 48v. Without pedal assist, I can hit 30 mph on straight land and no wind. With pedal assist I have seen 36 mph. After converting my Trek hard tail mountain bike, I have the cost of this kit (750c display, 750 watt motor) and a pricey 20Ah battery pack, I am in for a little over 1,100 dollars just for this kit and battery. I could have purchased a new bike, and let someone else do all the work for near the same price. Unless you are just bored and love tinkering (also make sure you have all the correct tools), I personally would just buy a bike and be done with it.The kit came with a crank arm puller, however you still may need the socket for removing the cranks shaft from the tube. Thanks to a local bike shop, I paid them 10 dollars to remove the cranks shaft. Also, apparently the old speed sensor used a flat head screw driver, the speed sensor that arrived with my kit came with a SECURITY star bit. Good thing I happened to have a security star bit set, or that is another tool I would have had to purchase.Security star bits have a metal dimple in the middle. Real pain if you have to purchase a security star wrench set just for this install. Oh, not near enough zip ties either. I had to use plenty of my own.

Very Powerful and fast, I was able to make it run for 35 minutes non stop on full throttle with one Dewalt flex volt battery. The speed sensor that was supposed to come with it was missing. Sometimes The motor and the screen shut off while you are using it, I have no idea why that happens. Other that I have no complaint. Over all a very nice motor. The 750w motor can go around 38 to 45 mph according to bafang.since they did not give me a speed sensor I have no idea how fast it can really go. They also gave me a head lamp to mount on the front of the bike. I connected all of the wires just to find that they had given me a light and a way to hook it up but no way to turn it on! That was too bad. So over all nice motor bad speed monitor screen and they did not send me a way to turn the headlight on. So that was how it got 4 stars. if they would have given me a speed sensor and a way to turn the head lamp on, it would have gotten five stars.

There was a problem with the display for this Bafang and the supplier helped me to set things straight.

It has plenty of power and is quiet but there is a delay between start of pedaling and when the motor kicks in and a delay when pedaling stops and the motor disengages. The motor provides power quickly so one has to be careful particularly on a steep hill to lean forward otherwise you could get thrown. The other thing I noticed is that the power settings relate to speed and not power. Using the 1919 code I set it up for 9 power levels. On level one the motor will try to get you up to about 7-8 miles per hour, level 2 about 9-10, level 3 about 11-13 etc.The installation is relatively straight forward. The most difficult part being the removal of the crank arms and bottom bracket. Pay attention to the direction of the threads on the pedals and nut holding the bottom bracket. A review of youtube videos on installation will be very helpful.

Had this kit installed on my Carbon Fiber Trek Mtn Bike for a 5 or 6 weeks now with 400 miles ridden so far over all manner of terrain and it is truly awesome so far. Powerful. Fast. Quiet. Paired with a 48 volt, Panasonic cell, 20A battery I've exceeded 40MPH, Gone on 40 mile trips and never used more then 40% of the battery. The seller Greenergia has been GREAT. When I ordered the kit I forgot I needed the brake lever sensors and not the default brake levers and they sent them to me fast at no cost other than shipping. In the last few days I have been working with them to resolve a no speed reading issue on the display and they have been Emailing me every day assisting me with a solution. They are sending me a new speed sensor at no costs to try but in the meantime I looked a little deeper and discovered a broken wire that goes from the motor/controller under the bottom bracket. Probably a rock kicked up and took it out. A little soldering and rebuilding of the insulation and its working great. Not even a manufacturing issue as it turned out but still they were assuring me if the new speed sensor didn't fix it they would continue assisting me until it was resolved. I call that excellent customer service in this day and age!

I wish there was a way to choose the battery connection at the time of purchase. Other than that, the kit worked great off the shelf

Installation was straight forward and the parts all feel quality made. Looks slick and rides smooth. I don't think I can ever go back to motorless!

Works well. The motor is solid. It is powerful and street-legal in my state. Seller (greeneria) also worked with me on solving a few problems and really went above expected on support. Strongly recommend seller.I have already bought another motor from them to use on my next project.Yes, the shipping is expensive and makes the price appear lower when browsing. Not my favorite business practice on Amazon.BTW, Love the 500C display