ECOTRIC Rear Bumper Valance Lip Spoiler Compatible with 2015-2021 Subaru WRX STI Rear Spat Bumper Valance

Looks OE fits perfect . Complete the lip kit . Very easy installation. Lines up properly. Aggressive look

I have a 2016 WRX STI and they fit perfectly. I have ti mention instalation is a bit tricky because I had to lower one portion of the exhaust the outer rubber mount to have access with my arm inside the back of the rear bumper to tighten the bolts. Other than that is all plug and play.

I thought this install would be really simple, it is not and about half way through I was ready to give this 2 stars. At the end though… woh, looks great, really does make a huge difference, it looks like it could and should have rolled out of the factory with these. Yes it’s a small thing but it really highlights the lower valance so much better than before. As for the install, what a pain! Some of the holes don’t quite line up but somehow they do in the end. One side I really struggled getting the bolt through the holes to tighten it, like it didn’t fit quite right, I had to clamp the 3 layers together to get the bolt on. Small gripe but why are the bolts silver? They really should have been black so that they blend in. I can’t give less than 5 stars though because I am so happy with how these looked once installed.

Read the mixed reviews decided to give this product a try hoping I get a good batch. Luckily all the holes lined up great, but it protruded about an inch past the bumper into the wheel well. Making my mudflaps contact my wheel. Upon initial inspection I noticed scratches on the products, and I found out why they are very soft plastic, looking at these wrong will scratch them. I liked the look but these requires trimming to properly fit like they are supposed to and after trimming they just look cheap and crappy. Will either be sending these back or throwing them in the garbage.

pop clip holes do not line up at all, I used the bolts it came with to hold it in the two holes nearest to the exhaust and double sided taped the rest because I didn't want to put self tappers in my bumper. It's pretty sturdy and does touch the mudflaps but it's nothing crazy. quality is okay other than the holes but you have to bend the spat itself to get it to line up to the holes nearest to the exhaust. It's $30 so I'm not complaining, for the more adventurous using self tappers I can imagine it'll be even more rock solid. 2020 WRX Limited.

Easy install, don’t even have to jack the car up and I’m lowered. Everything aligns properly and the hardware is legit. It’s fastened “right”. Zero issues. If i had to do it again, I would buy the same exact product.

Look great. The fit is ok in that they protrude just a bit into the wheel well space causing issues if you’re running mud flaps, but everything else lines up decently. A couple holes were slightly off so I had to do some finagling. Overall, not bad, but not the best, but kind of expected from China-produced automotive parts. I’d still recommend them with a caveat.

was expecting a low quality part but im very impressed by the end result. install was easy, some holes didn't line up but they were super close, all i did was widen 2 holes in the bumper. the provided hardware is good enough to use. the actual part itself was a little warped but didn't effect the installation or appearance.