KYN Universal 2T 4T 30mm Motorcycle Motorbike PWK 30 Carburetor Carb For Aprilia Suzuki Yamaha Honda Kawasaki BMW With Power Jet 30MM 30 PWK30 Fit for 100cc - 150cc engine

Awesome product. I bought it when it was just under $30 as an experiment to see if would run on my Ossa 2-stroke. Sure enough, BETTER than the original by a LONG SHOT! No primer knob to leak all over the place, minimal rejetting needed. Clean burning spark plug and cylinder, no knocking, pinging... Great fit and finish from a Chinese carb. Just an all around great performer! Heck YES, I would buy another!

Take your time to tune it and it will wake up anybike, I have it on my tao TAO dbx1 140cc and it woke it up gave it a deep more powerful idle and low and too end power, definitely would recommend. By the way I have my needle on the second from the top

Installed it on my 300 cc atv to replace the original one that I didnt like. Requires quite a bit of modification. And will need rejetted also the throttle has a longer thow then my thumb throttle has so will need to get a different thumb throttle.

It fit right..Worked perfect..no problems..just took awhile to get delivered because it is an overseas product.

Carburetor is extremely hard to adjustDoesn’t matter what Jets you put in you cannot get the idle set right very finicky 2006 cr 85. Even the local shop could not adjust Carb correctly. Used all of these jet sizes from. 30/115.All the way up to. 50/155.

Just what I ordered!!Perfect fit.

Didn't fit my Suzuki ds100

Seems to be working fine.

Just to start I'm a mechanic done tons of carb changes its not rocket science. This carb came to me completely faulty. One the throttle door/shutter is stuck wide open and moving it only just pushes it to its next stuck point (its supposed to move freely when completely uninstalled. Then the second issue is when I took the bottom off there a lot of small metal shavings all in the bottom which means even if it wasn't faulty id be taking this off over and over again till the metal finally made it to the bottom or got stuck in the jets which for my bike is a 20min break down to get at the bottom of the carb which isn't something i want to do or should be required of a NEW part to clean the jets ever ride or less then even a full ride. This part comes with its own maintenance other manufactures of PWK carbs don't make you do through be cause there parts aren't shipped with improper tolerances and not filled with casting and machined metal in the bowl.... DO NOT BUY THIS IS YOU SEE THIS. These carburetors are terrible quality and its very likely you basically bought junk or a headache. I can only assume this is a manufacturing issue and IF YOU STILL SEE THIS REVIEW I WAS EITHER STIFFED A REFUND AND/OR DIDNT GET A CLEAN WORKING PART. The item is worth less then gas plus shipping it back is even more .. WHAT A HASSLE.. so I'm stuck with this seller basically selling me a part that cant operate fully and made very cheap. This is like taking my money which doesn't make me happy as a customer … I clearly overpaid for this item as its fully faulty and cant be used as the actual housing isn't machined right and letting the shutter close fully or open fully or even move with free movement its literally stuck even with the cable not installed... REFUND ME and ill adjust my review!

Facile à installer et à ajuster!!! Fonctionne très bien..