HATCHBOX1.75mm Copper PLA 3D Printer Filament, 1 KG Spool, Dimensional Accuracy +/- 0.03 mm, 3D Printing Filament

Product works very well, sticks to build plate well, good quality prints.

What can I say really for just under £20 a roll this is some of the best and highest quality filament on the market that I have used. The filament has always been to the correct 1.75mm dimension and prints with excellent quality and has some of the best bed adhesion I've seen in a while. I highly recommend buying this brand only which is what I've done as they provide some of the best filament I've ever used. The best temperatures to print with for their PLA is 210oC on the hot end and 60oC on the bed and you can print it at almost any speed below 100mm/s but I used 70mm/s for quality. Once again I really recommend buying this over any other brand.

This is the 3rd reel ive brought from Hatchbox and its just as good as the first. If you want a good PLA in any colour this is the one. If you want good results time and time again this is the one. If you don't want to pay £30 plus for a 1 kg spool this is the one. If you want accurate results every time this is one one.This is a great PLA for your 3D printer.I have not been paid to write this review its just my honest opinion about this product.

Great colour and, like all the Hatchbox PLA I've used, is extremely consistent. Used around a quarter of the spool so far and no snags, extruder issues or layer warping / separation issues. The best PLA I've found and not even close to being the most expensive. I'm currently printing on an M3D micro which does seem sensitive to filament quality, so these days I only reluctantly buy other brands if I can't find Hatchbox in the colour I need.

Prints perfectly and has a lovely metallic sheen as long as you don't print really slow then it looks a bit crapSee attached rocket plane which looks ruff in the parts of the print is done slowlyI tend to use 215c bottom layer then 210C for all pla as it gives better layer adhesion and that works fine with this.

After using a couple of cheap, knock-off brands and running into a few problems (blocked nozzles/feed issues) I decided to get a little better quality. This works very well at a slightly lower temperature than other brands (191C works fine). I use the Da Vinci Jr which doesn't allow much fiddling of parameters, so this works well.

I really like printing with Hatchbox, I just wish it was easier to get in the UK!

Hatchbox filament is some of the best I've tried, it prints really nice and I never get failed prints with it.However the downside is that it's becoming increasingly hard to get hold of in the UK.