Camco EAZ-Lift 30-Inch Stabilizing RV Scissor Jacks - Features a 5,000lb Load Capacity - Heavy Duty Steel Construction - Set of 2 (48840)

Used these to replace the stock 2500 lb ones on the camper. These are built to lift and last!! Great jacks and easy to install with the right drill bits and bolts. Super sturdy!Update! - OK I put these on in Nov of 2015. And after 3 camping trips, one of the jacks had the pin that keeps the jack up in the upper position and it snapped off when putting the jack up. Luckily I carry tools to be able to fix things like this and was able to remove the jack so we could get home. I bought another set and noticed the pins that serve this purpose are not very big, and for something that will at times have some torque applied to it, may not be large enough. In checking the other reviews this seems to be a reoccurring problem and the manufacturer shoudl probably take a look at placing larger pins in the shafts.I am going to tap out where the old pin was and place a much larger one in its place. That way I will have some spares. I will put up photos when I do this to show the difference in the sizes of the pins. Changed form a 5 star to a 3 because it lasted 7 months before breaking after three uses. Maybe the maker will make a change to make this much better,otherwise the jack is great and heavy duty.OK UPDATE!!! They have changed to type of shear pin used, and now its much better built and a completly different type of system to hold the washer in place, its welded!! Can't beat that. Think they may have listened to the reviews and fixed the product! I replaced two on mine with the new style and will replace the other two when time and funds permit since they are better built now and will not have a problem with breaking like they did before! Highly recommend them now back to 5 stars!!

Had to replace the jacks all around my camper. Decided to upgrade to a more heavy duty one and found these. Price was good, install took about an hour or so (with removal of old ones), and they work like a champ.Overall very satisfied with the purchase.

I had four BAL stabilizers on my trailer and they retracted high to avoid any contact with rear-end scraping on the ground. However, I mis-judged a driveway entry and dragged the back end of the trailer on the ground causing some major damage to the stabilizers. I had to remove the stabilizer jacks from the rear, move the front ones to the rear, and purchased these Camco jacks for the front. (The front is a bit higher than the rear.) the new jacks work perfectly and retract high enough to not cause any further damage to the trailer. They are strong and easy to retract with the supplied nut driver attached to an electric drill.

The picture shows a 3/4" socket. Mine came with a speed handle. I didn't need either since I had the speed handle that came with the original set of stabilizing jacks, and I bought a 3/4" socket. I do like the speed handle that came with this package and will use it instead of my original.I have a 18.5 Jayco Swift SLX that sits rather low to the ground. I had been using the screw type jacks that get placed and stowed on each trip. There were many times that I couldn't use those jacks because they were too tall. As I said, my camper sits low. These fold down and are short enough that they fit within the safety zone for clearance. They are also small enough that they don't extend beyond the side of my camper.The foot is big enough that I could probably use it without a piece of wood underneath, but I use the wood just to keep them clean.These are rated at 5000 LBS each. My camper only weighs 2400 LBS dry and 3600 LBS fully loaded, so these are overkill.My camper didn't have mounting holes, but it does have a piece of angle iron where one would install such jacks. Installation was pretty easy.These jacks come with 8 screws (4 for each) which I think is also probably overkill. From what I've read, the screws are just there to keep the jack in place when they're not extended.

So over all great product but the listing is a little messed up for the product selection. Even selecting the 5000 30” 2 pack it still looks like the 7500 24” 2 pack. Was hoping for 6 more inches. But these were still a perfect replacement so not going to go through the trouble of sending them back. Comes with really stout hardware, better than stock, I reused the stock hardware for now.Also when you get two sets they include the drill bit. Happy with my purchase, just need to fix the listing so people are getting what they ordered.

These work exactly as intended. Don’t listen to the idiots on here using these things to lift campers or cars off the ground. They are NOT meant for that. When deployed these stabilized my camper wonderfully. Smooth and quiet operation. These were easy to install due to predrilled holes in my camper frame for such an addition. There are 3 different bolt hole set ups to use so hopefully you will find one that works for you. Oh and prepare to buy the proper bolts, locking and flat washers and nylon locking nuts for your install. You don’t want one of these flying off on the highway. These only come with screws and not very long ones at that.

Upgraded the lighter weight stabilizers on my camper. These are much heavier duty and very easy to install.

Better than our trailer manufacturer. I use this to provide additional stability when parked at home.