Low-Melting Point 203F Bismuth Lead Tin Alloy Ingot Fusiable

Exactly what was needed to make a cheap metal mold. was able to melt and pour from the heat on a plumbing torch. Was easy to clean up with a little torch.

Came in solid, no broken pieces, just a great ingot.

The melting point was a bit higher than posted but worked for my project.

Melted easily with a torch, I then made a suit of armor for my little man that lives in my pants.Currahee!

Use this to seal up Thread ring Gauge adjustment screw ports . Put a small piece of Kim wipe in port and fill with the alloy. If ring needs adjustment later just melt it out. Also works great for for weighting Pinewood derby cars

I purchased this from seller previously for metal work and was looking to purchase a lead free alloy from them and this came up and cert seems to show minimal lead. 203 alloy from Roto Metals has ~20-25% lead. The cert must be wrong unless they have modified their recipes. This (203Falloy) as I purchased is not lead (Pb) free.

one pound bismuth goes a long ways. this is the pure stuff. a flake of this to 5 pounds. product softens up any other metal. total satisfaction is my mind.

Too high of a melting temperature to melt in hot water.... Use the 158 instead if you plan on using water for the heat source. I bought them both just to experiment and if you mix the two together when they're melted, they become one with an average for the melting temperature ect.