Surfboard Skateboard Camera Stand Mount, for Gopro Skateboard Fixed Action Camera Holder.

Worked great for a couple of different skateboards. Did not wabble, stayed in place, and was able to adjust to various heights. Just what I wanted. Would buy again.

It’s hard to tighten and when you do it sounds and feel as if it’s going to break. Pretty wobbly when it’s on and the GoPro starts to change angle.

Fell apart before I ever got to use it.. which is actually great in my case because the helicopter would have crashed. So, for its absolute lack of quality and sturdiness, I present it with the rating of zero stars

I used this mount maybe 3 times for perhaps 2 hours of footage. In that time the 90° adapter that came with it flaked and fell apart first. Ok, kind of annoying but I can just 3D print another one, so I printed this white piece (seen in the photos provided). My 3D printed piece is still holding up fine btw.But the every next time I used the mount, the piece that holds the GoPro camera was broken. Somehow an entire piece was missing from one of the three rings, and the other two came off with a light flick. I'm lucky I didn't lose my camera.It's too bad because the clamp mechanism seemed to work really well, it's just the piece that holds the GoPro is made of cheap material that flakes apart easy.

Well made. Very durable and rugged. It will fit most skateboards and longboards.

Does what it’s supposed to

This products started rusting after a couple of week and now it's worthless as it looks as something from the last century.

The product was already broken upon receiving it. I am unable to use the product. Disappointed.

固定ねじの調整幅があまり無いのでスケボーと同じ厚さの物のみに固定できます。車のガラスみたいな薄板には使えません。他に流用できる場所は少ないと思います。ねじが固いので締め付けは大変ですが緩みにくいですね。

長めのボードにつける分にはあまり気になりませんでしたが、ペニーなどに付けると脚が当たって押し出してしまいます。また底面がペニーは湾曲しているので外れやすいのが難点。また、滑り止め用のゴムが剥離してしまったのでアロンアルファで接着し直しました。激しい使い方をすると耐久性には少し難ありかも。フリップなどをする時は、載せるアクションカムの重量も加わるので、バランスは少し取りにくくなる印象ですが、そこは仕方なし。値段は安いので不満点はそれくらいで良い商品だと思います。地面スレスレの面白い映像になるので、追い撮りとミックスすれば迫力ある映像が仕上がります。

コの字部分のパーツはプラ製なので締めすぎるとコの字部分が開いていきパキっと割れかねません。この部分は鋼鉄製にしてくれと思いました。それと、カメラ側の関節部分のネジ山が切ってなくて幾らネジを回しても空回りして固定出来ませんでした。ナットはキャップ型じゃなくて貫通したモノなので反対側からネジをねじ込んでネジ山を作ってから通常通りにねじ込んだら固定出来ましたがまあ実に中華品質ですねえw