Dressing Total Tire Kit, Single Car Kit - All Inclusive Tire Shine, and Cleaner Kit for a Lasting Shine and Brilliant Finish - 16 Ounce Tire Cleaning Spray - Made in The USA

I bought this Dura-Dressing for my 2018 2500 Silverado and for the tires on my Segway. I have read some bad reviews about this. The only way someone would say it’s bad is if they did not follow the instructions. For the first use I applied it to the tires on my Segway, it required 3 cleanings for each tire and allowing drying time between cleanings. I could not believe the amount of stuff that came off of the tires, by the 3rd cleaning the rinse water was clear. I waited until the tires were dry, using a leaf blower to speed it up. After the tires were dry I applied the first coat, after 15 minutes they still looked wet. Was I surprised when I touched them and they were completely dry! I applied the second coat and they turned out twice as shiny! If you are going to buy this, READ AND FOLLOW the instructions! It takes time to scrub clean each tire very well and apply the coating! Plan on an hour for each tire. Even the directions state “If you don’t like the product, you did not follow the directions!” I’m waiting on the purchase of my new tires for my truck and apply it to them. I included a video of my Segway tires. The video was taken on a cloudy day. Pros This dressing will never “sling” off on your vehicle. Dirt, mud and road grime will not stick to it. You do not need to reapply every week! A touch up may be required after a few months! It will not crack, peel or flake off! It gives your tires that WET look! Everything needed to get that great look your vehicle tires deserves is included. Cons, It takes time to do it right, you must clean each tire very well. If your not into reading directions, this will be the time to start.

I’m giving it 5 stars right now because I just got done with doing my tires. I must say that the finished result looks incredible. It was way easier to do it with tires off. Compared to when the tire is mounted to the wheel and installed on the car. It doesn’t wipe off when dry. I have not washed or cleaned the car with them on. It took many hrs to scrub and wipe off all the silicone on the tires. The first day I sprayed each tire with degreaser first, scrubbed, rinsed, then put dish soap, scrubbed, washed. Let it dry. At this point there’s like a white film that is kind of hard to scrub off. I had to re apply the wheel cleaner Atleast 4x on each tire. Each time allowing it to fully dry, assess where there’s left over silicone and scrub again. Finally once’s it done I applied 2 coats to each tire of the dura shine and let it dry completely before the 2nd coat. Here’s the end result. There is a photo of the car where the front wheel does not have the applied dressing and the rear has the durashine dressing on. Let’s see how long it lasts.

To start, I just bought this truck so I don’t know how or where the tires had been used. It’s a 2021 2500 HD Sierra Duramax with 17,000 miles. I anticipated the cleaning process and gave myself plenty of time. It took me 5 cleanings per tire to get it so the foam was white and didn’t have brown or black in it. The amount of stuff that came off the first round was mind blowing. 😂 I wanted to make sure to follow their directions to a T so I was patient and scrubbed for literally hours. It took me 15 minutes per tire for the first couple cleanings because they were dirty. The next few rounds went faster. I would guess 7-10 minutes. They were definitely clean after 5 go arounds. I used my backpack blower on all 4 after the 5th round because I was going to do the coating. For the other 4 rounds they were dry by the time I got back around but I wanted to be sure. The first two coatings of the shine I used a paint brush to get into all the nooks (highly highly recommend this) and the next two (4 coats total) I just went around each wheel and made sure the major surfaces were good and coated. They came out looking very sharp. I will say after 6 hours they had better look great. Now, to see how long it lasts and if that was worth it.

5 ⭐️ for the Product. | 3-4 ⭐️ for the Prep. Recommendations & Tips: -Block out a good chunk of your day. Took about 5.5-6hrs (Including detailing the whole truck). -Brand New Tires scrubbed 3x (1) w/white wall cleaner for the lettering. -Keeping the tires and wheels soaked while scrubbing helps with preserving the cleaner and allowed for spraying the cleaner directly onto the tires. Didn’t effect the chrome wheels but did have a bucket of soap & water handy cleaning them in between scrubbing stages. -To save time use an Air Compressor for drying the wet tires before applying the dressing. -Take your time, apply the dressing in sections & use the air compressor to dry as you go. -Used the padded (not sponge) applicator to get a good base coat on the tires. -Used a small paint brush to get every nook and crevice. Also, helped w/preserving the dressing. -Applied around 2&1/2 coats to each tire - barely used a 1/4 of the bottle. Aside from the prep this is by far the best tire shine I’ve used so far - no sling/dry to the touch, water repellent, & pretty shiny - Very pleased/impressed with the results - Tires look great! Curious to see how long it lasts but read if you properly prep the tires the dressing will last longer. Definitely recommend this product.

Amazing!! Its really reall!!!😍