Helunsi Cabinet Door Lamp Switch, 2 Pack for Closet Light, ON Off Normally Closed Wardrobe Touch Activated, for Open Close Sliding Pressure Doors Drawers Automatic - White

Compared to other door switches sold on Amazon, this one is much better quality and reliability. It operates flawlessly and has a positive click action that indicates when it is opened or closed. I mounted it near the hinge side of a closet door. I will say that it is bigger than some others. The mounting is very straight forward. Wiring for the 12 volt, 18 gauge wire in my system was fairly easy, but the screws on the terminals will fall out if they are turned out enough to let you wrap the wires around the screws. The terminals do seem very secure. I needed to cut a bit of plastic with a wire cutter to allow the wires to come out from the terminal area. This was no big problem, but good to know. I measured the resistance when closed and found it to be extremely low and consistent. Overall a good value and very reliable compared to some others.

The media could not be loaded. Did this a year or two ago and it works fine each day. Have an armoire that always has been hard to see into. Repurposed a three-bulb portrait lamp to light the cabinet. Not using middle bulb - too bright. Much caution if you're not handy. Mounted lamp way on top. Pilot holes needed. With left door open and right door (switch side) closed, held switch inside and pressed it forward to the right door until it clicked, ie, light off. Marked the wood with yellow wax marker. Drilled a half inch hole behind yellow line. Took a new regular extension cord and cut it a foot from the three-outlet end. Stuck both the long and short ends of the cut wire down through the hole in the cabinet top. It was unwieldy reaching up kind of inside the cabinet, but stripped the wires and attached them to the four terminals in the switch. Pay attention to keeping neutral and hot wires consistent. Aligned switch in front of yellow mark. Marked mounting screw holes and drilled pilot holes. Reassembled and attached switch, feeding extra wire up the 1/2 inch hole. On top of cabinet, lamp plugs into extension cord end like it would anywhere and long end drops behind outside of cabinet to outlet.

I installed these in lower cabinet running a 24v led strip system. The hardest part was figuring out where to mount it so the doors would contact. Both work and perform exactly as I hoped. I would absolutely recommend and would but again if I need. 1star off because instructions should specify in/ out or explicitly say it doesn't matter. I put the hot in on the screw furthest away from the spring mechanism. I did not have problems.

Works great, easy installation and great deal

I installed thus switch to operate 12v cabinet lighting in my camper. I have 1/2" overlay cabinets. I attached these to the inside face frame. They work great and are pretty small. They also have several mounting options.

The media could not be loaded. Piece of cake installation on 2 closet doors. Works perfectly!

Not reliable.... not good for kitchen cabinets....

A little weird to install with the two part design. I used 16/2 brown speaker wire (which is as big as you can use) and you have to cut out a section of the switch housing for the wire to pass through. Don't know why they didn't mold it with an opening.Because of how small it is one of your connection leads needs to be a little shorter to fit.However once installed it works well. I installed on a bifold closet door using a short flat piece of aluminum stock as the actuator (took a while to figure out how to make this switch work with this type of door).We'll see how long it lasts, if it fails I will update the review.