AB Tools 350kg Trailer Suspension Unit (Pair) & Cast Wheel Hub 4" PCD 1" Taper Bearing

Good product

Fitted these suspension units the day they arrived, perfect fit, trailer up and running again, good quality did exactly what I wanted them for, highly recommend this product and suppliers.

J'attendais beaucoup plus de sérieux au niveau qualité, il n'en est rien, je suis déçu , en premier l'emballage des roulements "ZERO" , qualité des roulements "ZERO", même graissé ils ronronnent comme un roulement à changer, pour aligner les 2 demis essieux , une galère, je doit faire 2500 km avec la remorque, j'espère que je n'aurais pas de problèmes avec les roulements car ils m'inquiètent !!!!

This is a very low quality torsion bar. If you plan to use it, I would suggest that it can not handle the rating of 350kgs. Do not plan to use this on highway nor dusty, dirty nor wet conditions. There is a hole in the dust cap to allow air to escape when adding grease… this allows water dust etc back into the bearing assembly. The hub is grease-able with a zerk fitting but the fitting needs to be removed to put the rim on the hub. The nuts are not the right angle for the rims and deformed the rim when torqued. Short story long… I would NEVER buy this item again.

No split pins for the bearing nuts.Not enough clearance between grease nipple and hub body to get a grease gun on.Dust cap does not fit---too large, won't fit into the bore.Incorrect wheel nuts.Have now purchased hubs elswhere, just praying the actual suspension units are ok.