Super Clean Chain Lube - 400ml. Aerosol 99470-A400W by Bel-Ray

As far as chain lube goes, not too sure how they would vary by much. However I have buddies with different chain lubes and I have noticed that theirs flings off more than mine does and creates a surface for dirt to stick too a lot easier. Follow the directions, shake for about a minute, apply to a warm chain, and wait about 10 minutes and you are set! I am very impressed with the claims that it does not fling, or create a sticky surface for road grime. (Obviously there will be a few specs here and there occasionally on my chain guard or what not) but nowhere near to any of the other products I have seen my buddies use. I have a Honda CBR600rr and a gold chain. Does not leave the chain looking thrashed or black. Goes on white, stays white until loosing its longevity (starts to turn grey) then I know to re-apply.) Seriously, great lube, will definitely be purchasing again. Good to stick with what you know works and this stuff definitely does!Side Note: The spraying mechanism is great as well (comes with the red straw). It sprays on evenly, and is easy to gently press the spray nozzle without getting too much or too little.

Bought to use on motorcycle chains, it stays where you put it, and doesn’t sling off.

This stuff works great. Used it for years on my motorcycle(s). As long as you don't mind the white film and occasional cleaning. This isn't the type of stuff you can just keep spraying on. It dries on (anti-fling) and WILL build up if you don't clean off the old stuff every so often. I'd just use WD-40 and a rag to clean it off, let the excess fling or drip off and re-apply. It's not just for motorcycle chains either, I use it all over the place. Works great on automotive door/hatch hinges. But like i said, it leaves a white film if you douse it on there.. So clean the area/item FIRST and SHAKE WELL (like most aerosols, it's worthless unless it's shaken up and mixed back together). Here's another "Top Tip" i would use old magazine covers or paper plates to hold behind the chain as i went to keep it off the wheel, fairings etc.. Spray from the INSIDE of the chain (if that makes sense)

I have used every chain lube on the market for my motorcycles for the past 50 years, but when I found the Bel-Ray brand, I stuck with it. This is the very best chain lube on the market. It doesn't fling off and it lasts a long time. It's a no-mess chain lube

Goes on clean - no fling off. Slick enough to keep the sprockets and chain mostly happy. I ride the bike until the chain is warm/hot, then clean it - rinsing it with hot water - let it dry in the sun, and apply to the warm chain. Seems to work well for me. Just make sure you properly clean the chain before applying the first time for best results. Quick shipping from vendor.