6x Bubble Spirit Level, 32x7mm Circular Bullseye Level Inclinometers for Tripod, Phonograph, Turntable - Fluorescent Yellow

Smaller than I thought but great value as you have 6 and they work great so overall pleased and I would buy again

Only 3 out of the 6 were accurate. Those worked well for fitting rifle scopes.

Used to help drill go vertical or horizontal. I used blue tac to attach

Leveling record turntable

I will level with you, these are perfect of all your leveling needs.Used them on a stand project and worked very well.

I have recently been through a frustrating process of buying and returning some 'high precision' circular bubble levels, each costing two to three times the price of this six pack.I bought these with no expectation that they would all be good, but hopefully at least one would be.Three were tilted, one rocked on a convex base, one has the bullseye marking printed off centre (but the bubble held true), and one was actually pretty accurate, bingo!I hate the idea of wasteful plastic junk clogging up the world. Buying six of these only to throw away five irks me, but all the more expensive ones I tried were junk anyway, and I finally got a level that works, for much less than I was willing to pay.

Good enough for the money, but they have a lip around the back edge, seems accurate though

they doing what they are supposed to do, good so far

I purchased this set of 6 levels for "initial" leveling of my new 3D printer. Starting off with a level surface is important for any number of hobbies and in my case the immediate use was for setting up the rough level of a new 3D printer. These levels have a center target that gets you within about 1% of level and are easy to just set down on a print bed or frame for quick leveling. They are inexpensive and easy to see and use. While they do not have "any" type of adhesion this is perhaps better and faster in moving the level to various places around your project and makes it easy to slide them along an X or Y axis. The levels seem well made for the intended purpose and my intention was to actually attach these to the four corners of my printer on a permanent basis but I have not looked into how I would do that (glue, double stick tape, etc. ?) so in that regard perhaps a little disappointing in function. I would also suggest this for resin projects and wood projects as well.

Set up a recently purchased turntable, dropped one of these on it and it was dead on level, so tried a second one and it also was dead on.All seemed to be well made.

Works as intended.

There are 6 of them so I can use them in many areas. I use them in my trailer to make sure it is level.

These are ok if you don’t need exact precision. They all show the bubble kinda around the same spot, but not exactly the same.