After you cut the zipper to desired length how do you get the ends to stay together without coming iut?

This zipper tape is not designed to have a stop. You will have to cover each end with a bit of fabric. The teeth are nylon so you can cut them with scissors. There are videos on Youtube that show how to add the zipper slider. I usually put on all the sliders I need for the entire length of zipper tape first. I can always remove any I don't need later. Next, I move the first slide to within the length of zipper I need. At the bottom and top of the length, I hand stich across the tape then add a bit of FrayCheck or plain white glue on top of the stitches and below or above. This reinforces the stiches and stops the area I will cut through from fraying. After the glue dries, I cut across the glued area with scissors. The result is a zipper that is held together above and below with stitches that I can zipper either way. I encase both ends in fabric so I don't see the stitching.

Is the red zipper tape a true red or an orange-red? Your competitor's is orange-red but you both display the same picture.

It's the red tape on the picture, but it's not as red as Chinese red.

Can this tape be used with 2 pulls, pulling in opposite direction?

I can't remember if the teeth on this is nylon (probably) then it can be cut to desired length and yes, two zipper pulls can be added going in opposite directions.

MebuZip #5 Antique Brass Metallic Nylon Coil Zippers by The Yard Bulk Coil Zipper Roll 10 Yards with 25pcs Pulls for DIY Sewing Craft Bags (Brown)

التفاصيل

الوصف

لديك سؤال؟ انظر ماذا طلب الآخرون

الأسئلة الشائعة