icepc 1 to 12 Multi Way 5V RGB LED Splitter Sync Hub with PMMA Case and Magnetic Standoff for 5V 3Pin ARGB Fan LED Controller Aura Addressble SATA Interface RGB Hub

I was going to make a custom PCB to reduce the wires around my watercooling radiator. These are magnetic and stuck right to the side. I cut the cables to custom length and these ended being a hero in a very expensive case build.Bought four of these and would highly recommend.

This device protrays itself as a hub but it is only a splitter. A true hub maintains the argb of devices connected to it. When software sees this hub, it won't know that there are 12 devices connected to it. So all devices will recieve the same signal.For some, this is a desired effect. But it severely limits the ability to have smooth continuos motion with the rgb efects.Additionally, the PCB was loose inside its case and I was worried that i might break the case while plugging in the cables. One side of connectors was not soldered flat and they all required bending to be able to fit the cables.This does come with one cable that was long enough to properly hide the unit.I am going to give this a few days and see if it grows on me. If not i will be returning it due to the loss of addressibilty in the rgb devices.

Piece of cake to install, works good.

I love it

I tried attaching this to the 3-pin RGB leads of my nine fans and also plugging in the supplemental SATA power, and then my PC wouldn't even power on. It was causing a short or something that prevented my PSU from powering on. Useless trash, don't buy it, it could end up ruining your PC!

This thing Killed my motherboard It had a short on the board Amazon send and smoked 2 sec after install would not buy

have 10 outta 12 slots used and it works as intended. kinda wish it had some rgb too, woulda been cool.