56750 Seal Puller

Great value and a great tool. This puller is sturdy and well constructed. It is strong enough to remove stubborn seals with no damage to the tool.

Worked well on my trailer bearing seal

Well made, worked great for pulling a rear axle seal.

The tool is a good value but is a bit tricky to use. It either takes two people, one to hold the wheel hub and a second to pry it out with a few sharp blows or you need to brace the hub and hit the tool with a large rubber mallet. I don't need the tool often so the low price made it a worthwhile purchase.

Wow this tool made pulling a seal out way easier than the screwdriver way. Super easy to use at a great price. It took me a few seconds and boom the seal was out. I'm glad I bought this for my tool box. It's a great tool and even better quality!

I had never in my life before removed an inner seal on a drum break. I read the Amazon evalutions (other's star ratings) and liked the idea that the Lisle Seal Puller did not break under rugged use. I watched some YouTube videos and saw other ways to do it. There were several do-it-yourself and make-it-up methods to remove the inner seal. I purchased the Lisle because it was designed for the job, a job I had never done before ... and it was relatively inexpensive ... and I have a used 2-axle trailer (four wheels) that I could experiment with just because it was used. The Lisle Seal Puller worked perfectly. I needed to put the drum in a vise to steady it during the pulling process. It took a little work but all four seals came out. The old seals were totally distroyed as you would expect from the pointed tips of the tool. The real trick is knowing what size to get for the new seals. The information you need to select the new seals is on the side the bearing wall which is not visible until you remove the old seal. I found a very helpful westco.net narrative in selecting the new seal; it says "Most boat trailer axles are rated for either 2,500 or 3,500 pounds capacity per axle. Most of the smaller axles, which are only found on single axle trailers, will use bearings that are 1 1/16 for their outer diameter. The part number for these bearings is 44649. Most dual axle trailers use bearings that are of different sizes. With the dual axles the inner bearing is 1 3/8 and the outer bearing is 1 1/16 in diameter. The part numbers for these bearings are 68149 and 44649 respectively. This second size is far and away the most common bearing set used in boat trailers. The hubs they mount in are often referred to as either the Small Ford bolt pattern or are called 545 hubs. The 545 designation refers to the fact that they have 5 lugs which are spaced on 4.5 inch centers (from the axle center). These very common 545 hubs use seals that have an O.D. of 2.56 inches and in I.D. of 1.72 inches. A commonly available part number for these seals will be Federal Mogul 473336." I went with this advice and it turned out to be the right advise.

Worked perfectly on removing an axle seal on 2013 honda accord

worked as described on my cv joint seal to transmission. A must change if your in there doing a cv joint axel. Tis is the right tool for the job.

用途によりますが､シール外し持っていた方が良いですよ。

Works well for stuck seals use it very often at work.

Makkelijk in gebruik. Heel goed.

Worth having in the box!

I believe the seal puller is the same as carquest sells for 50 bucks and works the same but are so much cheaper. Love the price and how good it works.