FAHREN H1 LED Bulb,18000LM Super Bright, 6500K Cool White H1 Bulb for Halogen Replacement, IP68 Waterproof, Pack of 2

They are really bright I love them other than I bought for a 2005 Kia sorento and none of the clips fit mine use the wire paper clip looking clip and I had to glue them in but other then that great product let’s see how long they last

These have been the brightest and most reliable LED brand I've found so far.

This product is working so far in my 2006 acura rsx but the instructions included are incorrect. There is a rubber housing that goes over the bulb to also keep in place. And the clip does not fully fit around this bulb to secure it. This bulb is a bit bigger than the original. I had to cut my rubber housing so that the hole was bigger and the fans weren't covered. 🤷🏻‍♂️ wasn't very hard but this was a bit of a pain to put in. 4 stars only because this was not a quick and easy install like advertised. Lights look great though. Just hoping they last with how they're in there.

After trying to find a decent set of LED bulbs to install in my car for the past few weeks now, I finally bit the bullet and purchased 2 sets of Fahren LED bulbs, one set for my headlights one set for the foglights. Installing them was easy. Had to get an adapter for the headlights but everything fit and worked out well in the end. Visibility is good, way better than the stock bulbs were. Definitely one of the best bang for the buck deals I could find as they only costed around 40$ for a pair at the time of purchase. I've had both sets of bulbs in my car since January and no issues have risen so far. They aren't obnoxiously bright either as long as you have the right LED compatible headlamps. Haven't been flashed by people on the road yet would definitely recommend these

H1 low-beam kit goes together nicely and is plenty bright. The low beam pattern isn't as crisp as the original dimmish halogens, and the H1 LED doesn't work as a daytime driving light the way the halogen does. I'm not aware that on these cars the low beam can be aimed separately from the high beam. If there's a way to do it, I haven't found it.Fiddly bits:1. The low beam bulbs on these cars are protected by twist-to-release waterproof caps. The driver doesn't fit under the cap. I cut a slot in the cap so the wires can pass thru and the driver rides outside. If you do the same, be sure not to cut through the big rubber o-ring that seals the cap.2. The spring-wire bail holding the bulb has a finger-loop on the end. This needs to be bent back a couple of mm to clear the flared fan housing on the bulb.3. Spade terminals on the pos and grround leads are smaller than Subaru's female connectors. Electrical connection seems adequate but best to shrink-tape the assemblies to make sure everything stays secure.

Bright! No flicker. they fit the house well. They got hot since these do not come with fans. But they never burned up, so that is a plus. Just a suggestion, but I would aim them down, or you will get brighted all the time by passing cars.

This is the third set of this bulb brand. Have never had any issues and they fit, and install perfect.

The output was better than I had anticipated, but I did return them in favor of the Terminator series and don’t regret that