Autel6937357203263 Dual Frequency 315Mhz And 433Mhz Rubber Stem Mx Sensor Quantity 1

seguire comprando

Programmed real easy

Without a doubt best TPMS sensor on the market. These sensors DO need to be activated with an autel tpms tool before they will work though. So don't buy one if you don't have the appropriate AUTEL tpms tool because they will be useless to you with out it(they are blank sensors ootb with no ID #) That said they have worked flawlessly in every vehicle I have put them in so far (Audi,BMW,Chrysler,GM,Honda,Kia,Subaru,Toyota,Volvo). One other amazing feature is that you can clone you old sensor ID # to avoid time consuming coding/programming procedures to make a new sensor work with your vehicle. If you old sensor does not read with your scanner the id # can be manually entered. You can even clone all the sensors to a second set of wheels for winter tire/wheel sets for easy change over in spring & fall. Highly recommend this productUPDATE: I saw some bad reviews that mentioned that the sensor(s) were installed then they tried to program the sensor with the tire inflated. They will only accept programming when there is less than 5psi in the tire.- 6/15/2020 3 years and 500+ Sensors with no comebacks yet or dead batteries yet!!!! The only hold up I had was with an 18 Camry that the sensors would not work correctly with but after 30 minutes with autel support we corrected the problem with a software update on my TPMS tool. These are the best!!!!- 11/24/21 Still working great!!!!

I’ve been using these for awhile now. Extremely convenient to be able to have 315 and 433 capability in one. I have yet to have a problem. The negative reviews on here are obviously folks who don’t understand what they are dealing with. The sensors can be cloned to your existing sensors or programmed with new id’s. If you program with a new id, some vehicles will require a formal reset. My suggestion is you talk to the shop you use regularly, don’t just think your gonna be able to make this work. Keep in mind not all shops and techs are created equal either.

I purchased these sensors for the first time. I usually use the older single frequency units, but I figured I would give these a shot.I tried to program them with an autel TS501 like I’ve done many times before. Unfortunately, the tool could not communicate with the sensors.After a bit of research, I found out that the TS501 must have the most current update to work with these sensors.After I updated the tool, they worked great. No issues.