Sunlite Standad Schrader Valve Tubes, Multiple Sizes

Easy to install Worth every single penny

This WAS the first time I replaced a bicycle inner tube, so my original review was worth less than my lack of experience. Once I introduced a tiny bit of air to the collapsed inner tube, it took up a bit of that slack that you can see in the picture and enabled me to somewhat effortlessly tuck the tube into proper alignment under the tire using both hands simultaneously, on both sides of the valve stem tucking at reasonably equal distances on the left and the right side around the rim to the opposite point from the valve. After confirming the absence overlap or pinching, I applied small amounts of air from the little compressor to pop the tire bead a little at a time so that it seated cleanly upon the rim. Start to finish was 3 minutes. This is a case in which I'd rather be lucky than good any day. Things worked out well and it wasn't as difficult as I thought it was going to be. I recommend this sunlight brand with Schrader valve for anyone having to remove and replace the inner tube on a 26 incher.

Works like it should

I like to buy a couple to have on hand so I don't have to go buy a tube. The price was cheaper than Ebay and the tube works fine. No unexpected problems. Usually the local bike shop is great but my son went on a ride with the bike club at school and he got a flat so they went to the LBS which happened to be very close. They changed the tube (the teacher had to pay for it) and it went flat again right away. When he got it home, I took the tire off and found a fairly large piece of broken brown beer bottle through the tread and into the inside of the tire. My son said ten minutes after leaving the LBS the tube the LBS put in popped and he had to push the bike back to the school. He should have pushed it back to the LBS but I wasn't there to suggest that. It was a big enough piece of glass that I had to throw the tire away, I'm surprised the LBS didn't catch it. I like to do whatever I can at home to save money and changing a tube is very easy.

Good price -delivered on time

So far, so good. Purchased a Bell brand (https://www.amazon.com/dp/B007SNUJEY?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1) and it was too big for my tire although it says anywhere from 35 to 43 mm it did not fit my tire. This one was a direct fit perfectly, i do highly recommend when you do the replacement to use a plastic bar tool, once you have it inflated a little bit and you put it in the tire, then you put that back on the rim, you got to pry it back out a little bit to get it to set back in the tire all the way, then continue putting the tire all the way on the rim. Then confirm before airing it up to what it's supposed to be that the tube is set back into the tire and it is all the way on the rim, then air it up to whatever it's rated for. For whatever reason it was a pain in the ass to find out exactly what tube I needed for the tire although I had the sizes, measurements reading through this product also had the best explanation on that. Also a big plus that the valve stem was American and not Presto or whatever cuz then I had to buy it after valves to go from Presto to american so I could air it up. I don't know, overall good product.

Having the exact size of "inner tube" for one's bike exists as a very important issue for myself. Given my recent tubes' (3; older; just a tad undersized, yet "they should fit, also 'definitely fit' ") very loud, nighttime (I was sleeping in all of these experienced occasions) "bang," followed by a distinct "hiss" (as the remaining air escaped the tubes abruptly awakened me); I'm convinced the "VERY BEST" way to choose one's "inner tube(s)" should involve one choosing "the exact size" inner tube for one's bike, rather than an approximate size based on "available" inner tubes of "nearly the same dimension." These "approximate size" inner tubes definitely "fit," yet aren't the BEST IDEA for one's bike. In my case the "older" (previously used) inner tubes' stems' "failed" with a "BIG BANG." The first time was the most traumatic, as I thought a "gun" had just been fired inside the building where I rent a room. EGADS! The "brand new" tube (have yet to receive the second one, as I only figured one would blow, not two! I was wrong) exists as much more flexible, pliable as well as incredibly easy to fit onto the rim/tire, simply by following the instructions inside the box! (I happened to buy "sunlite"). I doubt I'll ever buy only one tube at a time in the future! "When one blows, another's soon to follow," seems to be the best adage when buying inner tubes. It's quite similar to when buying "new tires" for one's vehicle. Always buy at least two "new" tires, placing them on the same axle of your "4 wheeled" (not 4 Wheel Drive) vehicle/automobile, not different axles. TY!

Good bike tubes

Neat & clean new tube.

Does not state anywhere in description that it's a singular tube so now I have to buy another when I could've bought from elsewhere.