ANCIRS 4 Pack 2mm Needle Test Probes, 600V/10A Non-Destructive Multimeter Test for Leads tl71 tl75

Great test probes at a good price. Prime shipping was prompt. Used probes right out of box.

These multimeter extension adapter probes fit onto my existing probes , used a little piece of electrical tape to secure both adapters, just my preference. Other than that they worked great for the price!

Im able to easily check voltage on circuit boards and molex connections.

Fit my probes perfectly

works for my uses

Muy buenas puntas de trabajo, son cordiales y duraderas

Well I guess you get what you pay for. These were a good price, but the common side (the black one) didn’t fit tightly onto either of my set leads, the Pomona nor my Fluke

I design (and need to debug!) printed circuit boards for a hobby. With current surface mount techniques it is easy - and sometimes necessary - to pack components together tightly. This makes probing difficult with a standard multi-meter probe without shorting different pins together. Shorting then requires more debugging to find what component you killed.These "needle" probe tips slip right on over standard multi-meter probe tips, and eliminate that problem. The shafts of these probes are metal with a plastic sheath that leaves only a bit of the tip exposed. They are quite needle like and when pressed on a soldered pin, tend to NOT slip off. Very niceThe plastic sheath slides up and down the shaft so, in very tight spaces, you can slide it down so only a tiny bit of metal is showing right at the needle tip. When slid up, this sleeve leaves around 1/8" of tip exposed.