3DTOP 12v 280w Silicone Rubber Heating Heater for 3d Printer Heated Bed 300x300mm

Heats up way faster than the pcb obe on my FT-5 printer. I just wired it into the play of my existing 12V heat bed, and placed a piece of cork on the bottom. Takes about 2 minutes to get to temperature instead of 15 so I am very pleased. Wish it had come with a thermistor, but I can't complain.If it helps to know I am using a MKS V 2 Board, and am powering this right off the board. I have it sandwiched between a mirror tile and a piece of cork.

Perfect for my FT-5!

Looks good