🛠️ Elevate your woodworking game with precision and power!
This 3-piece router bit set features 1/2-inch shanks and premium C3 micro-grain carbide cutters with silver induction brazing, designed to cut rails and stiles between 1-3/8" and 1-3/4" thick wood. Crafted from high-grade YG6X alloy, these bits offer superior abrasion resistance and are ideal for creating extended tenon entry door frames in solid wood, MDF, plywood, and more.
D**S
I liked
it worked good for me
C**X
Good value for the money. You'll probably need to adjust yours.
I run a small cabinet shop - mostly hobby but some commercial. I needed to make a 1 1/2" thick set of swinging bar doors for a customer. This router set did the trick. I don't need to make thousands of these doors so super high quality wasn't that important. But I did make the set of doors out of oak and the set remained sharp.The rail end pieces set depth with a bearing so I machined all those first. Then the stile grooves have to be adjusted for depth with the fence on the router table. I set up to take 1/2" at a time - leaving a little bit for a third pass. Once I got done, the rails and stiles would not mate up. On the stiles bit, there are washer shims between the upper and lower. 3 are 0.020" and 5 are 0.010". I used a 20 and a 10 on each side which gave a perfect fit.These are hefty bits so turn the router speed down - I was at 2 out of 5 and slow your feed rate. I would recommend making multiple passes.Overall, I would recommend these bits!
R**S
They work as good as the expensive ones
I’ve built cabinets for the laundry room saved a fortune doing it myself with recovered popular wood I got for free they took a little time to figure out the combination but once I did it was great
G**D
Adjustments were made, but I fixed it
It was cheap and I made a door 🤙
C**Y
Good deal
They work well for the money
S**C
Was able to match competitors
I ordered this for a special run of doors. I needed to match some existing pre fab doors and I didn’t want to spend much on a bit I will rarely use. The set was sharp and did a very good job on solid poplar. I probably would give 5 stars except for a little fuzzing and very slight chipping. That possibly could have been remedied by speed adjustments on the router.
F**M
1/2 inch router bits
The bits where more than I expected quality wise.
L**B
It worked for one time!
It went dull after first use and started burning through the wood, but no cutting. Save your time and money and buy something worth it.
ترست بايلوت
منذ 3 أسابيع
منذ يوم واحد
