Question 1

Hi. The installation diagram does not exist. Only a bad figure in the manual. May I have a clear installation instructions or diagram, please?

Accepted Answer

I agree with you.  I also did not find it very clear.  My advice is to pay close attention to what to what is written not the diagram.  It is very easy to install incorrectly otherwise. Also before you remove faulty sensor - not how the wires are attached and label them before removing. That way you can install replacement without instructions.  Finally - new time delay switch is touchy. I would set it to middle position. Good luck.

Question 2

has temperature compensation?

Accepted Answer

It may have temp compensation but locating it over an opening that is venting a pool area is beyond what the design is set up for.  Ron

Question 3

Does it work with regular led lights or only with dimmable leds?

Accepted Answer

This sensor works similar to a simple on and off switch.  If it is dark and motion is detected it turns on.  After a set period of time it shuts off.  The load is irrelevant as long as it does not exceed 300 watts.  So yes, this will work with both dimmable and nondimmable LED bulbs however, you will not be able to dim the dimmable bulbs.

Question 4

Where is the unit screwed in to? Thanks..

Accepted Answer

This is not intended to screw into a light socket as you seem to surmise.  It is intended to be attached to a knockout hole in an electrical box (either indoor or outdoor).  You will then attach its wires to power and the lights to be controlled within the box in accordance with the instructions in the package.  If you are not comfortable with home wiring, then I suggest you have the unit installed by an electrician.  Adjustment of these devices is tedious to ensure that detection of what you want to detect (presumably persons) is detected and what you do not want detected (leaves in the wind, animals, noise, etc.) is not detected.  This involves orienting the fixture and adjusting the sensitivity; this is a two-person job with whatever ladder you need to reach the device as it is installed.  You may find that you need more than one sensor to do the job; it's just not possible to have a reliable detection region that is wide and thin.  And, it cannot detect around corners.  Good luck.

ASIN	B0002YPKVS
Item model number	MS180
Manufacturer	EATON
Product Dimensions	6.99 x 8.89 x 12.7 cm; 168 g

Halo MS180 180 Degree Replacement Motion Security Floodlight Sensor, Bronze

Details

Details

Description

Specifications

Common Questions