for Mossberg 500 590 835 930 935 Shockwave Accessories Enhanced Slide Safety

Perfect..nice add on

Great upgrade from the stock selector on my shotgun. Easy install and works perfect.

Definitely an upgrade to your Mossberg shotgun. The stock safeties are notorious for sticking and not being adjustable due to a one-way safety screw. These have a nice adjustable Allen bolt so you can tighten or loosen your safety over time which is nice. The large thumb-tab also makes it much easier to toggle, especially with gloves on. They're also aluminum instead of plastic, which should last longer. I bought a Mossberg so I can still use it at 99, and I'm not sure why the new ones have so many plastic components compared to my dad's Vietnam era one.My one note is installation is not the easiest. During installation, my safety fell into the receiver and I ended up having to disassemble the trigger mechanism to get it back. Some forums suggested laying the shotgun on its side during installation to prevent this from happening, but I'm not sure how well this would work. Also, to remove the original safety screw I found it works well to put a piece of duct tape over it and then unscrew it as a normal screw through the tape.

Super easy to install, works better than the factory switch.

I haven't used the shot gun for decades and when i tried to unlock the slide safety it broke more than likely for plastic degrading.When i ordered the slide it came in a couple of days and it was easy to remove and install now the slide safety works perfectly.Original slide was black and the replacement Red looks just fine.

This works better than I expected. Just follow the instructions on you tube and your done.

Nice finish, however, the detents are just deep dimples, to get the safety to slide smoothly, it is necessary to make a short shallow groove leading into the detent. If you don't make the grooves, it will be difficult to move the slide between SAFE and FIRE. Before installing, be sure the shotgun slide is cocked, open, and the safety is ON or you will spend a bit of time recovering the internal safety latch when you remove the screw from the safety slide.

Mossberg 590. I had read the instructions and watched a couple video's. Followed all instructions about slide back and trigger cable tied. I laid the gun on its side to avoid having the safety catch piece with the threads fall into the receiver, but it did. removed the trigger group and held pressure against the threaded safety piece and tried to screw the safety catch into it. Tried for about 3 hours but could not get the ball bearing situated correctly. Gave up and took to my gunsmith. He said he had a heck of a time getting it but did eventually get it installed. Even done professionally its not as smooth as I had hoped. Wish I never bought it and left the original safety switch alone.