VCOROS Universal 3-snap Retro Open Face Helmet Visor Windproof Sun Shield Half Face Motorcycle Helmets Visor

Simply amazing

I purchased this for my F14 Flight Helmet, I had the black dark tinted lens, and I wanted a Mirrored lens (Wish they offered an iridium lens!! How about that?) Anyway, I needed to remove the hinge this lens comes with and cut it to the shape of the flight helmet lens, but while it is about 1/2 to 3/4 inches shorter nose cut out to top of lens, its plenty long enough to fit without any problems and is nice and dark. Sun is not blinding with this mirrored lens. An actual flight helmet HGU33 lens runs around 350 to 650 dollars US. So getting this for a few dollars vs. all that LOOT needed to get the same one, Needless to say I am THRILLED this, while I needed to cut it and adapt it to fit properly, it works great, slides nice and smooth, installed the center bolt for the clamp on the helmet visor protector. I will be getting a 2nd one for my 2nd HGU 33 Helmet from the Grim Reapers Squadron VFA 101, I just replaced my black tinted lens for my VFA-84 and VFA-103 Jolly Rogers helmet. The attached photos will show you the fit and finish of the lens in my helmets. The lens arrived with no scratches, well packed, and a protective sheet of plastic over the mirror outside face, (no protection on the inside? why I do not know) The plastic is very clear, not distorted, nicely and evenly tinted and works in my helmet well. I did have to cut it, sand it smooth, remove any plastic burrs with 800 grit sand paper on the edges and the lens is perfect, smooth, no rough edges to hurt my hands or cut my nose etc. I am Very happy with this purchase and so pleased the cost was a few dollars vs. over $600 for a mirror lens from a flight helmet site. I cannot say how well it will hold up with rocks and pebbles and other road debris on a motor cycle helmet setup but I think it will stand up to quite a fair amount of abuse. It was VERY hard to cut with an air jig saw, was easier to use a whizzer wheel to cut it and then sand it with a die grinder cookie pad to shape it and then smooth it with 400-600 then finishing with 800 grit paper on the bottom and side edges so I would think typical small road debris will bounce off the front surface, I cannot answer if it will scratch easily or not. I covered mine with masking tape to cut it and sand it then peeled it off to protect it from scratches. But seems very durable. I hope this review has helped you with your helmet lenses and helmet projects. Best of luck!

Cumple muy bien con su función.

Lens quality seems ok. I think in Thailand it would be $3 but ….. lens tint is good. I’m flying with it!

en principio muy bien al abrocharlo pero si despues decides quitarlos la banda que retiene los broches se rompe

I've used this sun visor all season. Still looks like new. No scratches after hundreds of bugs and who knows what else. Cleans easily. Stays attached to the helmet. Flips up and down with ease. Dark enough for sunny days. No glare. Also have a clear one from the same company, and I am just as happy with it.