DLZ 14 Pcs Front Suspension Kit-Upper Control Arm Ball Joint Tie Rod End Sway Bar Pitman Arm (3 Groove) Idler Arm Compatible With Avalanche 2500 2002-2006 K6535 K6693 K6696 ES3488 K80631 K6654 ES3609

I installed this set on my 01' 2500hd. Everything went together fine. My only issues was with a castle nut and cotterpin. Either the tie rod was,not drilled straight or the castle nut was off but I had a hell of a time getting a cotter pin through one of the caste nuts. The upper a arm came with nonservicable upper ball joints, no zerks. But it did come with an extra set of upper ball joints with zerks. I should have pressed out the non and install the others but....Time will tell, I'll update in the future.This is the update. Garbage. Don’t waste your money. My HD had 180k and I didn’t want to spend much money rebuilding my front end. I was hoping to get 50k a out of these parts before the truck was dead or sold. I didn’t get 5k miles out some of the parts. Tie rod failed, already had to replace one. Pitman idler arm need replacing already. Learn from me don’t buy these parts. It’s tempting....don’t do it.

Ball joints do not fit the truck it says so I had to go buy 2 new ball joints for a 2004 Chevy Silverado 2500HD 4X4

lower ball joints did not fit

after installing i was driving down the road and the lower ball sheered off at the neck going 70 miles on hour luckily no one got hurt but that i want my money back its not worth a life so i want my money back and possible damages IT NOT WORTH A LIFE

It was missing a piece, ended up receiving it later after contacting and ended up being the wrong piece, AGAIN. Not a bad product just needs work with the packaging process.

Would have been better off leaving the 14 year old factory parts on. After installing new parts couldn't really feel any difference at all. Only replaced factory parts because the rubber boots were cracking. In less than 6 months already replacing these parts due too failure. This is not a daily driven vehicle. Probably less than 5000 miles on these parts. Replaced upper control arms with moog and immediately could feel the difference. No more rattling In the front when you hit a bump and the suspension feels way tighter like it did new. Luckily i never installed all the parts In the set.

Horrible cheep made crap. Busted the bottom ball joint and didn't even have 10,000 miles on them yet. Do not wast your time trying to buy or instal this stuff.

The parts do not fit the 2500hd model so there for your stuck with a lot of extra parts and can't get your money back