CNUPSM Replace for Gear Selector Shift Shifter Cable End Catch Pair 1J0711761C 1J0711761B Compatible With Polo Jetta GOLF Audi A1 A3 TT B6 B7 SEAT

no issues. nice tolerances on the fitment and looks built identically to the 20 year old ones I took off. 2003 OJ2 transmission

Stamped made in germany.. quality is best I've seen so far off amazon.. needs to be filed a bit on the smaller one (for up/down) since the inside of the ID looks mushroomed. No big deal, round file fixes that. Some permatex black rtv sealant filling the gaps around the shaft bushing helps tighten up some shifter slop... no need to wipe it with a wet finger.. you won't see it while you're having the neighborhood hotties screaming from the passenger seat while you're banging through the gears.. lol

The first set I bought was trash the fingers wouldn’t even open freely with the slide so I can fit into the cable. So I was smart enough to buy a second pair and The bigger bushings twist lock to open fingers does not work it’s off gauge. I can probably get it to work with some trouble

Easy to install ( using videos) and calibrate. Had a situation where finding the gears in my manual transmission was getting hard to do..these new ends took a lot of the slop out of the process and the calibration afterward put me back to a very smooth and easy shifting experience. Fun to drive again!!

The quality of the part seems good. However, the holes are too small and will not mount on the gear selector silver pins. May work for other VW models, but not on a 2002 MK1 TT.

Easy to install, corrected all the shifting issues going into reverse and overdrive. Highly recommend product.

Fit like a glove

I am a master tech. The received part has female thread grabbers that are made for a smaller diameter cable shaft. When you try to close them over the OE male threaded shifter cable end, the received part won't close. I used a zip tie for extra clamp force. Don't waste your time and money. Look for another solution than this brand. If the supplier would just drill their part with a bigger hole it would be fine.

Both are stamped with VW OEM part numbers. Fit my V6 Bora perfectly.

The cable ends were as described and direct fit. My 2006 Jetta 5 speed tdi shifts much smoother now.

They fit nice and everything and seem decent quality. But you cannot fully close them on the cable. I forced the F out of it trying to close it and didn't want to break them so I left it. Then time goes by and suddenly my 5speed was a 3 speed. Cable slipped inside and stripped the f out of it. Not saying they won't work. Maybe I got a bad batch. But a fair heads up if they do not close fully, return them as they will fail eventually.

One of the cable catches didn't fit and required drilling pin holes out. The other cable catch jaws do not fully close and prevent lock and proper cable tension adjustment to be made