Cryptocurrency Miner Rig Case 8 GPU Ports, Mining Rig Frame with Barebone Motherboard for BTC/ETH/ZEC with SSD, ETH Machine System with 2000W Power Supply (Without GPU)

Was a ok price, and was shipped very fast. The case was dented up some. The power on/off button wires were cut in half. The power supply was 110 only which is ok, seems to work pretty well. It was put in upside down and not screwed in all the way to the mounts. The bracket is probably what cut the power button wire. The CPU is heat sink only, no fan, its also only a 1800mz Celeron (very old CPU). The MSata that came with it seems like its going to fail. It will not boot with start up sometimes. I ordered a replacement to try to clone over and replace. Also no drivers, couldn't find drivers online anywhere. I was able to install Windows 10 and it picked up all the drivers for Ethernet and others. Msata SSD is also a bit small for modern GPUs to use Virtual Memory. The one I ordered to use to replace was much bigger. Fans keep the case cool pretty well. I had high hopes for the case as a bargain priced case. Also the case online didn't match the one I got in, there are no PCI retention clips on mine. The screws that came with the case were mismatch and missing some. Msata SSD had no screws and wasn't mounted, it was in a plastic bag so I had to pull a NVME screw from another computer to mount the drive.

Product came very fast. Other than that it’s all bad. Pins bent. Pcie ports broken. Whole case dented up. Missing cables and ssd. Probably Would have been okay if they just stuffed the inside with some styrofoam or even paper would’ve been better than nothing. Psu was literally hanging down banging on every component in the machine during shipping. Will not buy again.Edit: the cables and ssd were in the box. Not the actual rig box. Sitting in the bottom of the box it came in just sliding around

Lots of missing screws and psu was almost broken from frame.

It showed up looking like it was thrown down the stairs. It was also missing quite a few screws. I made sure the main electrical components worked, which they did, and straightened out the rest of the case. Overall it works just fine so far, but needed to be bent back into shape.