RV Awning Lights, 12V 16.4FT White Camping Awning Lights, Motorhome Travel Trailer Food Trucks Van Waterproof Canopy Led Strip Lighting, RV Exterior Underglow Light

Quick shipping. Great price. Easy install. Even though it was my first time. Turned out great. As bright as the original and 1/4 of the cost.Prep the surface with an alcohol wipe down. It helps a lot with adhering. Very happy.

Absolutely hands down wowFast shipping and easy installationLighting is amazing 👏

Easy to slide into track on awning. I did not remove the backing tape, I left the protective cover on the tape and slide into the track, I needed to cut off a couple of inches with a pair of wire cutters. Works great lots of light.

I am restoring a vintage Shasta camper. Just finished the paint and decided to add a bit of flare to it by adding a LED strip along the top. The strip easily attached to the metal awning tube and was flexible enough to completely attach to the round metal. The 3M tape held very well. During the restore I had added a 12v system and switch and already had the wiring ready for this job. Once connected it all lit up on the first try. It really makes a difference on the looks of the camper. At night it really glows. I am very satisfied.

Easy install. Must clean surface with alcohol before adhering to surface. Installed mine 4 months ago, looks good and have not had any problem with sticking to exterior of my RV. Swapped out porch light with one with switch. Then wired to new porch light.

Perfect replacement for my rv. Exact fit.only had these lights up for about a week but no problems so far. Nice and bright. I can't comment on the sticky back of lights since my rv has the c channel that I just slide the lights into. Light strip seems to be built well and so far so good.

I missed the return window by 4 days unfortunately. Didn't even last a month.Initial installation was a breeze, I was able to install it on a pre-existing channel for my previous lights which lasted 4 years. The channel is protected against rain and sun by my awning.I trimmed the excess as instructed and protected both ends with silicon. I even went as far as soldering the electrical connection and using heat shrink to cover against moisture and rust.However not even 1 month later a large section of the lights are burning out, and I mean BURNING. none of the other LED's are hot to the touch, they are warm but not hot. However all of the burnt out ones, although not producing light, are SCORCHING! To the touch. Look at the pictures and you'll see the clear protective plastic turning black from the heat. I would have kept this product if some lights had gone out. I mean for the price, that would have been fine. But BURNING out to the point where I had to pull my hand away. This is a fire hazard. Since I missed the return window and there's no support page, I'll simply have to buy another brand and spend the weekend taking this apart.What a shame.

Product as described, perfect fit to the awning slide, easily installed, bright lights!