SUPREMETECH 12 x 12 x 0.12 Inch Acrylic See-Through Mirror, 30% Transparent

This mirror was suppose to be see thru and it was a normal mirror with matt back…. Ruined photo shoot plan !!!

Mirror has no protection on it at all and the mirroring comes off with just cleaning alone. I literally was using a soft paper towel to clean it and it removed the mirroring. Very disappointed

I used this with a laser cutter to make some perforated plastic lenses for a Halloween mask. It cut incredibly cleanly, and the plastic protective coating on both sides prevented any scratches or marring during the process.Even without the perforations, the plastic is transparent enough to see through.The only downside is that I ordered a sheet that was a little too thin and therefore it's easy to break if flexed, but that is buyer error and not the fault of the manufacturer.Can't beat the price for the quality of the material. Just remember to remove the film on each side after cutting.

Used this material to create lenses for a mask I 3d printed.It is exactly as advertised and I have no complaints.Material can be scored with a sharp x-acto blade, moved over an edge of a table, and pressed down upon in order to cut it into smaller sizes - note that like any acrylic, you must apply even pressure and make sure your score mark is deep enough.If used in the application of a mask/lenses, assuming the interior of the mask is as dark as possible, the transparency is comparable to wearing sunglasses. The opposite side is a perfectly mirrored surface.Did not have any damage for defects when I received it.

1mm/3mm - 30%Wurden ohne Mängel geliefert, verpackt in Pappe und Bubble-Folie. Wie kratzfest das Ganze ist kann ich noch nicht sagen, aber vorsichtig anfassen geht ;) Gute Spiegelung und Durchlässigkeit

Really good quality, help me make a True infinity mirror! Thank you!