Two Jaws Bearing Puller/Remover, Adjustable Two Jaw Puller Tool, Bearing Puller Tool, Carbon Steel Pump Pulley Remover (8 inch)

For a cheap puller, this thing does the job for sure. Needed this to pull a 6203 bearing off an alternator shaft. It was pretty seized on there. I threw this puller on there with a 14mm socket on my impact and let it eat. There was a point where it got pretty stuck and I thought for sure the puller was going to snap. Iv broken a lot of pullers over the years. But nope. This bad boy powered through. Didn’t show any signs of damage after that extreme use case. So. I’d recommend it. It’s built well enough for light/medium duty pulling. I wouldn’t pull a large diameter bearing off a motor shaft with this. But for smaller stuff like a 6203. It works very very well.

Great quality, cheap price, easy to use, somewhat durable, great size, great appearance. I used it to pull bearings in my Toyota transfer case. I couldn't get under the bearing but I was able to grab the lip of the bearing where a c clip goes. Worked great but it did bend slightly. In all fairness the book said I needed to apply heat to remove the bearings and I did not apply heat. That's a cold pull. A 14mm impact did the trick on this thing. My only complaint is that it bent, but that was a tough pull.

Worked perfectly. Rusted on pool motor bearing. Used a DeWalt impact wrench on slow speed because it was to hard to turn and hold by hand. Pulled it off with ease. Couple that with the fact that I ordered it at 8:00 pm last night and it was on my doorstep at 7:00 am (I paid $2.99 extra to expedite), and you can't get a much experience.

When pulling a wheel bearing from a 3,500 lb axle, on a utility trailer, a tool like this is an absolute must-have! I had to remove a bearing without this tool a few weeks ago, and it took me 6 hours in 95 degree temps, and no shade, in the parking lot of a 7-11, on a Sunday. Conversely, with this tool it only takes about 5 to 10 minutes, less after I learned a few tricks. See the photo. You will need a C-Clamp to hold the jaws together, as they pull off under pressure. 2nd, you will need a big, strong screwdriver, to keep the entire thing from twisting, when under pressure, but, this fixes the issue completely. On hand on the screwdriver and one hand to twist the wrench to pull bearing off. Lastly, that little toy "pin" of a handle that they include is a joke. Just toss that out and put a big wrench on it. Follow my advice as shown in my pics and you will pull even the most stuck wheel bearing off in 5 minutes. Good luck!

I purchased this bearing puller for a small motor. It removed the bearing with ease. I didn't even need to use a socket at the top handle. Looks very sturdy as well. I recommend this over the three claw designs, unless you are working on a car with huge bearings.

De calidad y rápida la entrega

It bent on the first bearing. Cheap quality.

This puller worked extremely well. Bearings came off very smoothly

Great quality does the job.

HAVE USED MANY TIME ALREADY AND WORKED VERY WELL

Yo lo compré para extraer poleas de bicicleta, si me funcionó. Es de un material bastante solido pesado.

Fast Delivery 👍🏻👍🏻👍🏻 , 2 Jaw pullers are good for the price 👍🏻👍🏻👍🏻

easy to use and good quality. removed a seised snowblower pulley bearing from the shaft. there is not enough space for other tools. this one worked very swell for this purpose.