Chanzon LED Driver 600mA (Constant Current Output) 18V-34V (In: 100-240V AC-DC) (6-10)x3W 18W 20W 21W 24W 27W 30W Power Supply 600 mA Lighting Transformer for High Power 20 W COB Chips (Plastic Case)

I recovered a LED ceiling light fixture. I ordered the driver with the same spec as the original piece. After replacing the broken one. The light fixture is working as a new one.

Easy to install, worked perfectly to repair expensive bathroom vanity light with 3 LED bulbs. Nothing worse than to buy an expensive vanity light only to have it fail shortly after installation...well this is the economical solution. Just remove your light fixture and match the original power supply specs. Solder or use wire nuts to attach wires and a piece of double sided tape or hot glue to attach power supply to fixture, reinstall and you're good to go.

Already failing in less than 3 weeks after installation. Light is blinking in and out as the voltage falls below the required threshold for the driver. It worked for about 13 days before starting to fails. I did swap out a different driver from another identical fixture to rule out the lamps (they are fine).

I did a bit of research when my hall light went out. Ordered according to specs on failed part. This part came fast and I was able to replace the custom one in the light fixture with this. Needed to MacGyver it as it didn't align with the screws the old one used... but it's been working for several months now without issue.

Our Costco (brand unknown) light fixture for our dining room went out after about 8 years of service. I figured it might just be the LED driver, so I ordered a couple that had similar specs to the one it had and tried them out. One didn't work, but this one did. Perfect operation for over a year now, at a fraction of the cost of a new fixture.