KC02 600mW FPV Transmitter with 600TVL 2.8MM 120 Degree High Picture Quality Sony CCD Camera for FPV Multicopter

*Edit*It works perfectly fine if you figure out the issues. The wires in plug that comes with VTX is not correctly placed in order. Red is used for Ground- and Blue is used for Voltage+. I plugged camera into the supplied power from VTX blue wire and it started squealing like it was being fried from too much heat. I tested the output voltage from VTX and 19.8 Volts seems way too high for this camera and will burn it out. I finally ended up using filtered 12 Volt and Ground from PDB to power the Camera instead of the blue wire from VTX.Do not use the supplied plug from VTX to Camera. Cut that harness and make sure you power camera from PDB or it will be noisy.Camera is the best part about the purchase with an awesome OSD but needs lots fine tuning to work. I tried it today in the sunlight and all I got was yellow shadows and outlines. It worked perfectly fine last night in very low light but needs to be adjusted for bright light.Camera Settings:LENS - ManualEXPOSURE -Shutter - AutoBrightness - 65AGC ----DWDR - OnWHITE BALANCE (WB MANUAL) - ManualColor Temp - ManualBlue - 64Red - 43BACKLIGHT - OffDAY & NIGHT - AutoD>N Level - 144D>N Delay - 5 SecN>D Level - 112N>D Delay - 5 Sec

I purchased five of these units. I simply rewired the camera and VTX connections to plug separately into my FC and it worked flawlessly.Got out to three and half kilometers with a clear picture.For what its designed to do it does the job for the price. Sure...They are better cameras and vtx[s] out there but this combo has not let me down. Maybe I've been lucky 5 out of 5 isn't bad.

Product works, but has an extremely unfocused and dim picture. Have used my FPV goggles with other cameras and never had this problem. Also tried a run cam with this transmitter and no problems.Spend $10 more and get a better setup unless all you need is the transmitter, which works great.

This works very well at long range at first it didn't work well because of the cheap antenna, but I put a clover type on it and it is a great price. I have it linked to a tactic display , great picture.

Absolutely great deal with the included camera. Unfortunately, my luck with VTX's lately is bad. This unit arrived faulty & would not display an image on my camera. After three separate occasions of seeing an image and then cutting to static, i realized the board wasn't staying powered on & was constantly resetting/overheating.Would like a replacement or refund :(EDIT: The company contacted me & offered a replacement. I changed my review to 4 stars!

Bought this system after preusing others and reading reviews. I just connected the vtx and camera and fabricated power/ground leads with bullet connectors as I intend to tap into the power distribution harness on my Elev-8 quadcopter. The system works great! No problem with initial hook up and test, and it was easy to install on the aircraft. I retested by powering up the aircraft and everything is fine. I have not flown it yet, but expect to have a great experience!

Not let down BUT not sure if it’s me but was hoping for better, I bought this to have a on board video cam for my nitro rc and hey it works NO PROBLEM but I guess I was hoping for more but can’t really explain what I mean, would I recommend these for the price and being my first time doing this YOU BET again easy setup easy to use and they do work as said. I was just hoping,

Great picture with tons of range. Gets me far enough away that I'm worried more about failsafe than video loss without any breakup. And for what it's worth, I'm using Realacc antennas.... as cheap as it gets ;) First vtx was doa, AKK's customer service gave me a discount code for a vtx that brought it to $0.20 for the replacement. Which was far more convenient than sending it all back through amazon and waiting for a full order replacement.