Gold Guitar Bass Push Pull Potentionmeter, B500k with Control Pot Potentiometer, Volume Tone Shaft Switch Pots (Pack of 3)

Always keep these in stock for general switching on guitar and amp projects. Decent enough quality.

Very poor quality potentiometer I was very careful not to overheat the lugs however they do not function smoothly, two out of three

The quality is mediocre. Not bad for the cost however

These pots worked well for the job. However if you have very tight fitting knobs and have to pull them off again the shafts can pull right out of the pots

Doesn't work well. Won't go to zero on my bass. Generally don't have a good feeling about these lasting or maintaining noise free.

good for the price

Out of a pack of 3, only 1 knob survived being installed and removed more than once. I build and swap a lot of guitar parts and will often reuse knobs and wiring when possible. With these, 2 developed issues with the pull not functioning properly on one and the other not pulling up at all after being heated and cooled and few times. I WOULD recommend these knobs if you are sure it is a 1 and done situation, but would not recommend them if you plan on reusing them on multiple guitars or setups.

Quality is not equal to higher priced competing items. This item is very fragile.. normal soldering iron temps like 30 watt irons will inadvertently destroy the internal mechanism... IE no ability to tune sounds. Push pull remains intact but no variability. I tested with ohm meter to verify and found no variation in ohms. Thus useless as intended... tone control. I have purchased 2 sets of these (6 units)... two of the units failed after soldering in place.