Bumper LB RB & Middle Piece Kit for Xbox One Controller with 3.5mm Jack, Xbox Elite Controller

Shipped fast, arrived in prefect condition sealed in package. Fits like a dream in my elite controller, no hassle at all getting it in, bumper buttons press nicely with good retention and feel sturdier than the stock bumpers ironically. I was worried the pieces wouldn't fit or would be defective but that wasn't the case at all. Highly recommend these to replace your bumpers on your elite controller.

The screw got driver got scrapped after one use and it’s super small and uncomfortable to use. Basically useless even for a one time repair

I spent 45 minutes trying to figure out why I couldn't get the bumpers and center cover to click into place before I finally compared the replacement with the original piece, and saw the replacement had a plastic tab in the middle that wasn't supposed to be there. Once I broke that tab off it fit together relatively easily. Lucky I didn't break the plastic trying to force it together with an extra piece of plastic on it, though... and I also worry that the extra strain of having to take it back apart could reduce the lifespan of the flimsy plastic. Time will tell.

These things are crap. Honestly they'll last maybe a month before breaking. they're way cheaper plastic then the orginal part which means it can not hold up to any abuse or use. Also the replacement front cover hole isnt the right size so the power button wont fit right

Works just as intended. I had left out of state for a few weeks and while I was gone my brother got ahold of my elite controller and broke them bumpers. I was upset but once I found these online it made me feel a bit better. The installation was pretty simply and it’s quite nice how it comes with the tool needed to open the controller.

Overall the install is pretty straightforward if you have taken apart an xbox controller before. It's a little tight to snap back together. My only issue I had is the prong on the right side which stops the bumper after pressing it was bent slightly outward, causing it to unhook and pop out of the controller after a button press. To fix this I just had to gently bend it into the correct position and reinstall it.

This was perfect. The bumpers are same quality as any other plastic. Install was done in about 10 mins. Everything works perfectly now. The black bumpers on my Elite controller look pretty dope as well. I just wish MS would redesign these things. The bumpers do NOT need to be one piece. They need to be a two piece set, that way they don't break at the mid point.

Item fit as anticipated however broke in the same location as the original. Durability poor, lasted less than two months. I would not recommend buying from this seller.