If I have only two wires behind my switch, one is load and the other is neutral? Should I install this between two wires?

Between neutral and hot on the load (lamp) side. Per the instructions. If you have one wire in and one out, it is likely the switch just switches the hot and the neutral is with the other neutrals (usually white wires) in the switch box.

How do you install this at the switch? Does it go between the white neutral on the switch and the neutral in the wall?

Between the neutral (while) and the hot (black) and it does not matter if installed behind the switch to be honest one of the lights if there is more than one being switched by the same switch. Note, however, that if also using a Lutron electronic dimmer such as Maestro or one of the others, those types are very large so as small as this unit is, there is probably not enough room for it inside the same box so you will have to install it behind the light.

Operation Mode	[POSSIBLE] automatic
Current Rating	1 Amps
Operating Voltage	120 Volts
Contact Type	Normally Open
Connector Type	Awr
Brand	Lutron
Terminal	Physical
Item dimensions L x W x H	1 x 1 x 1 inches
Circuit Type	2-way
Actuator Type	Motorized
Contact Material	Metal
International Protection Rating	IP00
Number of Positions	2
Upper Temperature Rating	1 Degrees Celsius
Controller Type	Ring
Control Method	Remote
Connectivity Protocol	X-10
Color	Black
Wattage	1.2E+2
Unit Count	1.0 Count
Number of Items	1
Manufacturer	Lutron
Part Number	FBA_LUT-MLC
Item Weight	0.64 ounces
Product Dimensions	1 x 1 x 1 inches
Item model number	LUT-MLC
Is Discontinued By Manufacturer	No
Item Package Quantity	1
Batteries Included?	No
Batteries Required?	No

LUT-MLC

التفاصيل

الوصف

المواصفات

لديك سؤال؟ انظر ماذا طلب الآخرون

الأسئلة الشائعة