DNA MOTORING Pair Headlight Assembly Compatible with 2003-2006 Chevy Silverado 1500 2500 3500 1500 HD 2500 HD Avalanche 1500 2500, w/o Factory Cladding, Chrome/Amber, HL-OH-CS03-4P-CH-AM

Fit good. Nice replacement part.Ease of installation:Revel lines are great.

I have a 2006 Silverado 3500 that I bought recently where the headlights were so glazed over I couldn’t even see at night. I bought these and found that the fitment was very tight but in the end they look amazing. I was having trouble putting the pen in the hole on the top headlight, it seems that diameter is just Slightly too small. But it does finally push through and it holds in secure. Even if these last me only a year or two, they would be worth it for me because the quality looks very nice and also has a great projection on the ground with the light.

They look amazing. I used to have a smoked out headlight assembly that made it really hard to see at night but with these, I’m pretty sure incoming lanes hate me with how bright the lights are. Also, It can be adjusted using a hex key.

Almost everything about these head light housings was good, they look nice, same look as the originals, fairly easy to install, they are a little on the economy side if you know what I mean, definitely not the lowest quality but I'd say about in the middle, great for the price. so the only real complaint and the reason for the minus 1 star was the fact that every one of the light receptacles fit my lights perfectly except one.... I can't tell you the amount I had to sand off to have it fit, and then I had dust stuck in the housing itself, which I stupidly tried to rinse out.... I will just help you now if you have to sand one of the holes, just get an air duster and do NOT get it wet, or just return it. Also one of the wings that the pins slid through, broke, but I made it work, like I said not the best quality but definitely not the worst, overall I'm pretty happy.A-

Don't buy the cheapest out there. The only adjustment is up and down. The difference between low beam and high beam is molded into the design. If it is off, no way to adjust it

Cheap China crap, To begin with the passenger side headlight kept popping the low beam headlight fuse and I got out my multimeter I found the molex plug wires were populated backwards (negative wire was in the positive spot and vise versa). Next the middle headlight bulb was inoperative, upon further investigation I found a two wire white molex plug inside the headlight housing to be unplugged. Fishing it out to replug it in was next to impossible due to the short wires on both male and female sides. I did like that the wires were marked so knew what they went to but if I didn’t a factory wiring diagram knowing where to tap them in would not have been any fun. So once I had the passenger headlight and both turn signal lights installed I got the drivers side headlight out of the box and found the light housing on the inside of the headlight loose and flopping around, upon further inspection I found the cup side of the ball joint style adjustment fitting damaged and there was no way of repairing it due to it being on the inside of the headlight housing. I was very disappointed after about three hours repairing and installing just to remove them and return them due to bad assembly. (The pictures attached the white plastic cup inside the headlight housing is broke and missing a part of it. The black ball should be snapped into it.)

Great fit just what I needed !

Great replacement lenses. Existing bulbs plugged right in. Easy to install in 15 minutes. Fit my 2004 Silverado perfectly.