Amazon BasicsHard Camera Case, Medium, Black, Solid, 18"L x 14"W x 6"H

Being retired military, I have used dozens of Pelican-brand hand cases (and many no-name brands). It's hard to beat the absolutely indestructibility of a true Pelican case. However, this case comes very close and at nearly half the cost. No, I did not expose this case to the rigors I put my Pelican's as replacing them would be on my dime, not my rich Uncle's! If you need hard-case storage, I highly recommend checking this out - I doubt you will regret the decision.

When I ride (ATV) I take a Go Pro, two Garmin Montana 600 GPSs, a Nikon AW-120 rugged camera, spare batteries for all of those and chargers. The first case I had for those was rubbish. The sides bent under minimal pressure because it was thin plastic. I did not want to repeat that with this case.I wanted a case to carry just my camera with the lens I use for general purpose, rugged and waterproof because it's going fishing with me.I am really pleased with the outcome. First, the case is MUCH nicer than I expected. It is a lot sturdier and much better made than I expected. It does have an "o" ring seal around the opening so it should be waterproof. It also has a pressure relief valve. And the pick-'n-pull foam is sturdy, not thin cheap crap.My method of putting the camera on the foam and drawing an outline with a yellow highlighter worked pretty well. As you can see from the photo without the camera I left some foam on the bottom level to add support on the underside. I left some extra space where the lens attaches to the body so I can get my hand/fingers around the lens to lift the camera out. And in the last photo you'll see I added the two spare batteries.Again, I am really pleased with the case and would highly recommend it. I think it is very good value for money. If I decide to build a bigger case to carry additional camera equipment, I will definitely get the big brother to this one.

This is a very sturdy case for many uses .

These things always get me. For some reason they always seem smaller when you actually get them in hand. I bought two of these. The medium and the smaller one. The build quality is great from what I can tell. I don’t think you’d be able to tell the difference between a named brand one vs these. These can do the job. There was pluck-able foam which made for easy installation of your tools or gear, I just wish it had been just a tad bit stiffer. But If you’re looking for something to protect your gear and not as expensive as the high dollar one. I recommend these. Plus I like that there is not 1,000 sizes.

Sturdy well made adjustable padding great product

Others have written (positively) about the general features of this case and I concur with those conclusions. But I wanted to leave this review for a specific use - holding a set of the Rokinon/Samyang Cine-AF lenses launched in 2023. This case is as close to perfect as you can get for this purpose - and at a really great price.I ordered this case the same day I ordered my new set of Rokinon Cine-AF lenses. I had been looking for a hard case that would fit the set well (not too big, but still enough padding.) The measurements on the product description indicated this would fit the bill. The lenses and the case arrived the same day and after (carefully) pulling the pick-foam from the right spots, it became clear the case was exactly what I needed. The fit is snug, but snug is safe. There's even room for a fifth lens when the 20mm comes out.The latches are tight, but I suspect they'll loosen up some over time.

I wanted a case for an Auber PID, (an external thermostat) for my smoker. I had been storing it outside, unprotected, in an outdoor kitchen area. I wanted to make sure it was protected from the weather, moisture, dirt and dust. I thought about getting a Pelican Case from Amazon, but the size was just off and the next size up was too pricey.After researching it on Amazon, I found that Amazon Basics had a very similar case that was just the right size. When I received it, I was surprised and very pleased at how easy it was to pick away the pre-cut foam to get a custom fit. There is also a second piece of foam if it is necessary, which in my case, it wasn't.I can't compare this case to a Pelican because I've never owned one. I realize they are considered the Mercedes of this category, but if your needs are more basic, as were mine, this is an ideal way to protect small electronics with a hard plastic case that shuts super tight in order to keep out the elements.I think this case is a great value and a very well designed product. I wouldn’t hesitate to buy it again!