CANOPUS Car Sound Deadening Mat (80 mil 18sqft)

The media could not be loaded. I apologize for the more blurry pictures, it was a screenshot from the video. All in all, great product. The adhesive on the back is extremely strong. It's very easy to cut if need be. It does perform really good when it comes to sound deadening. I can hear a bit less road noise and no rattle after installing just the little bit on my door behind the panel. I'm sure if I did the whole door panel it would block out so much road noise. Definitely will buy more for any future products! It helps a lot with sound, especially bass. It makes the bass sound a lot cleaner and tighter!

Used this product on a skid plate for my XT 250 motorcycle. It worked very well to deaden the sound of the engine, very sticky and is holding up well. Also bought a cheap 1 1/2" roller to roll out all the ridges imprinted on the foil backing to make sure it sticks. Easy to mold to shape needed and cut. Would definitely buy again.

This REALLY quieted down our 2023 RAV4 Prime XSE Proximity Speaker that is super loud when in reverse or driving around below 25 mph. This was also fantastic with insulating my new Sony XAV–AX6000 microphone so when we make phone calls, everyone says how super quiet it is.I'm an old Operations Director... and I did a bunch of research into all kinds of independent tests and this CANOPUS is made in the USA and tops of its class (like 10-12 dB less than the other brands)!Hope this will help others out there... continued blessings!!! 😇

FYI if you don't already know, most of the noise comes from the wheel wells so DO THE WHEEL WELLS FIRST! And you probably don't need to do anything else besides that because 90+ % of all the noise comes from the wheel wells area (from road noise as the tires roll on the road and vibrate the air). Don't bother with the floor, the doors, the trunk, or the roof unless are looking for that last 10% of improvement because you are a car stereo enthusiast (or you like to waste money and do extra work LOL). I put multiple layers of butyl sound mats totalling about 1/4 inch on my four wheel wells (plus about 2 inches farther around the perimeter of the wheel wells), and just a little bit on the front floor (driver and front passenger floor) but I probably didn't even need the floor. The wheel wells made a HUGE difference. My car had NO sound insulation whatsoever and was horrible to drive on the highway, now it is PLEASANTLY QUIET and a joy to drive. I actually also put alot of sound mats on the middle and back floor, but it didn't make any difference so I removed it. So I recommend a minimum of two 80-mil layers on all four wheel wells, but preferably four layers to total about 1/4 inch. Or use three layers of the 120-mil mats. The more the better, but it seems to me that 1/4 inch is enough to bring the noise down to a luxury level.

Good product easy to use. You can cut to the size you need for certain areas. It is a bit expensive considering, but this is probably one of the more inexpensive choices.

Amazing. Very sticky. Easy to cut but super strong. Easy to work with. Cut back the sound and the heat in my sxs cab

Really works! I used this on the outside of a metal fuel pump enclosure for a boat diesel heater. The fuel pump would make a "thump thump" sound which is normal but disturbing for sleeping. After covering the metal enclosure with this the sound was gone. This is an "off label: use for this product but it is heavy, sticky, and sound deadening. Works.

Very high quality and great value and very easy to use. Very help with vibration reduction and very sticky. I would buy again as a great value and so easy to apply.