3CYYAP Replacement Digitizer Touch Screen Glass For Fuhu Nabi 2S SNB02-NV7A Tablet

Works great. All materials and tools included. No Instructions though and YouTube was no help. So here's how to install. This is the front screen you are replacing. You have to take the 4 screws off back so you can plug the screen in. Have to use small screw driver to pry open the unit from the sides. Now, from the front, you pry off the screen--it will splinter, so be careful. Leave any glue behind you can-you'll need it. You will have to unplug old screen--have to flip up the little transistor on back-where it plugs in, and pull out the little flat plugin---and now you have to pry up the square that is stuck to the board. Once whole screen is removed, you will have to add the two-way glue strips around the front where the new screen will set. The roll of two-way glue is tricky---roll the bottom glue side off the side so you can get hold of it to get it started, leave the top on. Now run it around the front a couple of times--once ready, peel off the top side of the two-way glue. Make sure corners have some adhevisive in them. Now ready to stick the screen in. Clean the 2nd screen still in the unit real good. Now peel off the backing on the new screen and stick it in ( you will have to feed the plug through the hole. Push the new screen down real good. Turn unit over and feed the plug in the resistor thingyr, flip down the little resistor lid and pull off the adhevisive backing so the little square can stick down. Wala.... dont forget to pu on the back and screw it in. Now you can take off the front protective film.. Hope this helps!

My nephew's break their tablets all the time. Installation is easy. Make sure you have a heat gun to melt the adhesive to separate the screen from the unit. There is a few videos on Google demonstrating the replacement process.

Everything you need and easy to use.

I liked the fast service, the tools with the ordered digitizer was much needed

I replaced my daughthers tablet and it fit pretty good.

Did not fit our Nabi 2