Can you change the torch head?

Sure when the Hoses pop off by themselves you could probably put a diff6head on ! Don't buy these they are dangerous!

Can it cut cast iron?

All depends in the thickness and the length of the item your cutting. In most cases the problem is not the torch, is the cyclinders. The map gas last but the oxygen run out to fast. It should be equal, but in my personal experience, I was not that lucky. Example: I needed to cut a fence post (2" diameter), my saw battery was to low, I then pull out the torch I was able to cut the post but it used two oxygen cylinder and one map gas to cut a 2" pipe. Cast Iron, it will cut it, but make sure you have some extra oxygen cylinder. By the way, make sure its not windy, or else you need to ignite many times, which in the end you will regret purchasing this item. In other word, it very handy for small project.

Manufacturer	Mr. Torch
Part number	HZ-7145B
Item Weight	1.22 Kilograms
Item model number	HZ-7145B
Color	Black
Material	Stainless Steel Brass
Power source type	gas-powered
Installation Method	Gas Welding
Item Package Quantity	1
Cutting Diameter	5 Inches
Measurement System	English/Standard
Specification met	ANSI Z87.1-2003, CSA Z94.3-2007
Specific uses	Commercial/Residential
Included components	oxygen MAPP/propane cutting torch kit
Batteries Included?	No
Batteries Required?	No
Item diameter	5 Inches

MR. TORCH

التفاصيل

الوصف

المواصفات

لديك سؤال؟ انظر ماذا طلب الآخرون

الأسئلة الشائعة