Rudder Clamp for 24 to 55" Trolling Motors, Kayak Rudder Kit for Kayak, Canoe, Angling Boat, Canoe, Jon Boat

Great product!The process was right, and it doesn't what it's supposed to. Took about 10 min to fully install, and was pretty straight forward.Tried it on the water the same day, and the results were clear, especially on my 1436 jonboat. Usually it turns in very weird way due to the flat bottom.This rudder fixes that and also keeps me from having to tackle back and forth while trolling.I'm using this on a MinnKota...the one from Walmart that we all own.

Perfect upgrade for my rear trolling motor to keep my boat running straight when steering the boat from the front motor I turn both on and I'm cruzing

Likes- Stepless feature is great a provided a smooth transition in speeds. All trolling motors should be made this way. Very light weight. Short shaft works very good on transom mounted Jonny Boat Bass 100.Dislikes- the distance between forward and reverse is too close and sometimes hard to get in the stopped position. The mount appears to be a little light for a 90lb thrust motor. The mount is smaller than on my 30lb Minn Kota, but has not caused any problems yet. The motor is a little noisier than my Minn Kotas or Newports, but that has helped me know when the motor is not in the stopped position. No significant speed difference over my 62lb thrust Newport and this 90lb, and no noticed increase between the 7 and 9 settings on the motor. However overall it has performed well and would buy again if it continues to perform well and has longevity.

Just as described

I used it with a 60 Lbs trolling motor. As far as functionality goes: It does help (about 25-35%) improvement. The effect is (of course) more noticeable at higher speeds. As for the installation, it sucked big time; they sent four screws with no bolts, and the screws didn't even fit and were too short, so I had to buy my own and ended up drilling the holes to fit the new (bigger) screw size. The three stars have nothing to do with the installation and everything to do with performance.

The media could not be loaded. Everyone said the screws are short. Mabye but with a little modification to the rubber pieces it fits PERFECT. You need to cut the rubber pieces and put them in long ways in the one side that is fixed to the rudder ONLY. The you need to cut and shape the rubber pieces it itt as a gaskiet/washer between the rudder and th clamp (See my picture). This helps two ways to keep the screw from coming loose and also to makeup the small gap between the rudder and the clamp. If you don't do this and just tighten it down the metal nut will work it's way out from the plastic clamp. I think the manufacturer should include instructions somewhat like this to make it easier to installHope this helps people.

I absolutely love this, much quicker turn response!

Works well but I don't like the trailing edge with all the spikes. I'm sure they were part of the design and might add to how well it works.