TMB Single Extra Large Universal Polyurethane Floor Jack Pad Adapter

This works perfectly! I needed to raise my 2008 Mazda 3 up using a floor jack, and was very concerned about damaging the underside it, which is why I purchased this product. There's a huge amount of these on Amazon, which is great in a way, however it makes it difficult to choose. Well, with this one I made the correct decision.The slots in it are deep and the rubber it is made out of is thick and solid enough to support my car while it was being raised without damaging it. Additionally, it on my the saddle of my floor jack perfectly, which has a saddle that is about 4.5 inches. It is also solid enough to raise your vehicle even if you're not needing to use the slots in it, but are just needing something between to saddle of your floor back and what you're lifting.

This was bigger than I expected and was very high-quality. I had to return it because it didn’t fit my HarborFreight Pittsburgh 3 ton low profile jack. I really wanted to keep it, but it would have taken too much work for me to modify it to fit.

Works great, very durable. I use it to jack a BMW X5 with no issues or deforming. Groove works great for jacking at pinch welds on a Corolla. Originally the pad did not fit snug on the jack, I use a 3 ton jack from HF, but after a few uses it conformed to the jack.

Purchased for a Toyota Highlander along with the jack stand braces. Works great to fit the pinch weld between the opening. I can't say for sure how wide it is, but it's wide enough to fit the pinch weld with no problems. Fits right on top of my jack and doesn't wiggle around.

I have a 3 ton Pittsburgh low profile jack from Harbor Freight and this did not fit on it at all.

My truck has a plastic shroud under the front end that resembles a skid plate. Being that it is plastic, I presume this is actually just to improve aerodynamics. The problem is this shroud covers the cross-member which is where the floor jack needs to be placed and therefore risks damage to the plastic. There are some ten bolts securing the shroud making it a real annoyance to remove just to do something as simple as an oil change.Enter the Polyurethane Floor Jack Pad.The pad fits the saddle of my 3-ton Craftsman jack perfectly and securely with no side-to-side play. I recently used it when I was rotating the tires on my truck. Not only was everything stable, best of all there was no damage to the shroud. It was equally stable when jacking the rear of the truck under the differential.The pad also gives my jack almost 2-inches more in height which is a plus being my truck is a 4x4.NOTE: Although very stable, safety should always be observed when working on or under a vehicle. Always be sure to use wheel blocks and/or jack-stands of the appropriate weight capacity for your vehicle before working under it.

It is big

I bought all four as I have a few jacks and low to the ground cars. These should last a lifetime. They are large size and should fit any large side saddle on floor jacks. The four are a good value for the price.