TML BSP 3/4" Pair of Bath Tap Cartridges Quarter Turn x 50mm x 20 teeth (Supplied with Solid Brass screws) (Pair (One of each))

These valves are well known for failure so I knew it was only a matter of time until I needed one. I looked around all the local shops but no-one stocked them, I found these and took a chance that the measurements I took were accurate.The part arrived quickly and had a nice weighty feel and seemed to be great quality. To be honest was an absolute doddle to fit, pop the old one out, replace and tighten, job done. I now have a quiet non dripping tap for a fraction of what it would have cost for a plumber!Just be aware that there are quite a few variants so make sure you order the right one, and make sure that you get the correct turn direction. These came as a twin pack for hot and cold taps marked red and blue so in the unfortunate event of the hot tap going the same way, I'm covered.Great product, great price!!

Bought these to replace a leaking one in our bath taps. Quality seems good, not to tight or loose to turn but were a little too short. Top tip. Check ALL measurements, then check again, there are so many variations, spine count, base width, top height, spine height etc.

Surprisingly difficult to find these in brick+mortar shops. These 3/4" were an exact match for what I needed and work as expected - they turn more smoothly than the factory fitted items did. Very happy.Not cheap, but still cheaper than replacing the mixer tap itself.

Can’t get this locally anywhere, amazing to find it on Amazon, delivered fast and fit perfectly job done.

Easy to fit