COUKIU 10 FT PVC Floor Transition Strip, Peel and Stick Molding Trim for Threshold Transitions with a Height Less Than 5 mm/0.2in, Carpet & Floor Edging Trim, Carpet to Tile Transition Strip(Black)

We had a large (1/4 inch) transition between our painted concrete and our luxury plank. The typical transitions don't look good and tend to get knocked out of place. These look so smooth and are easy to wipe up when dirty. I only needed a strong pair of scissors to cut it and just applied pressure back and forth to get a good seal. We have had them in place for about 6 weeks, and would never go back to the "wood style".

A little short for the height difference in my floor but that’s not the products fault. The strip is exactly as described and perfect!

It worked, but only in a closet doorway where it gets very little traffic. Granted my rug to wood floor was fairly high due to padding under rug. It would not work at the bedroom doorway where livingroom met the wood floor. For that I opted for an aluminum strip that nails in place.

Easy to do, I just wish it laid flat better, adhesive isn't super strong so will probably need to replace often

Tried to use this on my floor transitions and after following instructions, cleaning the floor, measuring, and placing it on the floor, it did not stick at all. Tried everything and it just slid right off the floor as if I didn't take the backing off.Don't waste your money

I used this strip to transition from indoor/outdoor carpet to a bare concrete floor. The transition thickness was just about for this type of carpet. The adhesive is very strong and the installation was easy to to.

Great for transition from tile to carpet tiles

The stickers on the back aren’t strong enough. Also, it is hard to lay the strip flat since it comes rolled up.