Powell-Peralta Tail Bone White, 8"

Of good quality. Was bigger for the 8 in board son have has...had to trim and reset screws. Product functions and sent as described. Just a difference on my end. All good , understanding all things can be different. Just noting was bigger than our 8 in board....

I bought this Powell Peralta Tail Bone for a cruiser skateboard I have setup. As with all things from Powell Peralta, this product is quality. I’ve been purchasing skateboards and skateboard supplies from Powell Peralta since the mid 1980’s and I’ve never been disappointed. Thank you George and Stacy!

Back in the day we used a rivet gun to mount these on. Not wanting to drill through my deck, I used a counter sink drillbit (available here) up from the bottom instead of the directions-suggested top. I’m so much more inclined to tail brake now riding downhill on our nice pathways than grind away my deck. This is easily replaceable. -wish it included a sticker.

Fits perfectly on a Santa Cruze Bart Slasher. No trimming required. The instructions said to use a 7/32" drill bit but that's too big, I used a 5/32" and it worked perfectly.

Wide enough for this board. Even had to trim a bit off the sides for a perfect fit. Slides really well. Odd smell to it but seemed to go away after a while. Better than a homemade plexiglas tail guard!

Note this is made for a 10 inch board, However I trimmed to fit my 8.25 inch board. place on board, trace along board and cut 1/4 inboard from trace. Also you will have to re-drill your holes and Countersink. Clamp to cut with Jig saw and sand with high speed sander. Dremel's work but take longer and there is lots of white plastic residue when cutting. From the picture it works be more patient than me.......

No screws included as per instructions. Bag was torn.

Used a drill bit smaller than the screws, and "wobble expanded" so they wouldn't bite too hard on the board, and cause a space when driving into the plate. The third one, that's what happened. Tried backing out the screw (power tool), stripped the head. There was enough left for me to use a small straight edge bit, along with a an impact driver, to pull it out. Drilled out the pilot hole again, used the straight edge setup, when the screw hit the plate, it sucked it down to the board hard. Super happy with the slide of the nylon. Will buy again

You will need a drill

I had to saw this to fit a 10" shaped deck with tapered tail. It's very hard. High quality.

Muy bien producto, pero necesitas de un sujetador para que no se te mueva a la hora de hacer las marcas, yo lo hice con una perica de presión. En mi caso está un poco grande, pero como solo lo uso para frenar con el tail, me va bien en mi cruise

Me rappelle mes jeunes annees

Todo cómo esperaba.