White ABS 3D printer filament,ABS 3D Printing Filament 1.75mm Dimensional Accuracy +/- 0.02 mm ,2.2 LBS (1KG) Spool 3D Printer Filament for Most 3D Printers & 3D Pens,DAZZLE LIGHT ABS Filament

Not as white as a piece of printer paper, it has a tinge of "natural pla" color, but I think it looks really great.Also it printed great with no bubbles. Would recommend, I'd like to print a lot more with it.

I've had 2 rolls of this filament and had good success. Prints at 240 for me, and I use a glass heated bed at 90 with a little ABS juice and a brim. The color is sort of a transulent (but not transparent) off white and has a smooth nylon like finish - but still is easy sanding/finishing like other ABS's. I had some Inland white ABS that was bright white and had a more of a casting plastic/resiny finish that I liked, but it needed printed at higher temps and there were a few more warping issues. I'll keep buying this unless the price goes up (it featured a $2 off coupon) or I run into problems in the future. It features a great balance between price, finish and usability.

Brittle once extruded. Has bubbles but not a lot. Biggest problem is it's weak. Easily breaks far easier than PLA once printed. If you don't need the strength ABS usually supplies it's okay.

From the start, the white ABS has had problems with breaking. My first print came out okay probably because it was very small and not very detailed. From the second one on, if the filament actually came out then I would have to constantly watch it or it would stop coming out or I'd hear the telltale "snap, click click click" of the filament breaking and unwinding on the roll. I've seen it break when the printer isn't even on and hasn't been used that day. It will break in the middle of a very small print (1"x1"). It will break when the printer hasn't been used for a couple hours. It will break after the printer has finished printing. It will break in the middle of the Bowden tube. It will break right at the beginning of the Bowden tube where I have to remove the tube just to get to it. It will even break when I just turn to look at it. It will miss spaces in the middle of prints, sometimes it will print in the air and sometimes it will act like it's printing and there's nothing there. And I may be a beginner with my first printer but even I know that this isn't right. And should it really be getting so much filament "shavings" on the gear that pushes the filament into the Bowden tube? I only gave one star simply because it was shipped in a reasonable timeframe. Otherwise I really should have waited for a better quality filament to be available - my first and second picks weren't available when I bought this. I would have saved myself a lot of frustration.

Yikes! While filament with black lines. Looks like dirt from China is included.

I have purchased three rolls of this filament so far, and it is fantastic. I like the slightly milky white color, and print quality in my Ender 3 has been great.

It worked, and if you can find it cheap (prices fluctuate wildly), it's not bad. Non-standard roll size, so I couldn't use my spool bearings and instead had to use the hangar arm, which is unfortunate.

Bought this expecting poor quality considering the price, but it printed very well once I got a proper enclosure. The only slight negative I have is that the white is more of an off-white, and isn't completely opaque. I'd say its probably about 85%-90% opaque.