EZDIY-FAB PCIE Gen 4 16x Extreme Flexible, High Speed Riser Cable PCI Express 4.0 Port GPU Extension Card-Right Angle Connector [11.8in/30cm]

Decent cable that should do the job & is total invisible.

I have this running into my 3080 and it is perfect. No issues at all. No depreciation in speed, bandwidth or card performance whatsoever. Simple plug and play.

Purchased this for my Corsair 5000x case. After reading some reviews of other branded cables not lining up with the standoff mounts, I purchased this cable. Pleasantly surprised it fitted the mounting holes in the case with ease. Booted the pc, and checked with gpuz it was running at full pcie gen 4.0 x 16, also ran 3dmark pci express test and Timespy with no issues.Second riser cable I've bought for different builds now, great quality both times!

Is a good product,good price. unfortunately for me it doesn't fit because too long and i had to send it back.

Am happy with end look

When using this cable I found consistent issues with the item causing my pc not to boot, even with dropping the BIOS to a lower spec when it would boot that far didn't help. Decided in this case to go with installing the card straight into the motherboard

This was a nice product , but sadly the holes was not wide enough part t fit ICue 4000 case is now returned and did not align up with holes , had no use for it as it did not fit my purpose .

Suitably flexible but fundamentally it didn't run pcie 4.0 on my pc. Now this might not be the cable, but having to run 3.0 to keep it stable (yes all the hardware is 4.0 capable)

I was afraid that it will not fit or match my thermalake case. The screw holes perfectly aligned with the nuts on the case and flexible cables made it easy to install.This is also cheaper than the thermalake pci 4.0 cable.

Estaba desesperado por encontrar un buen adaptador PCIe y no estaba seguro si este cable iba a ser suficiente una RTX 4090 pero esta perfecto, no me bajo el rendimiento y es un cable flexible, estaría genial una versión en negro

I'm gonna start off by telling you that if you're planning to install this on a Thermaltake Core P3, you're better off getting the straight adapter, and not this 90 degree one. I've used the EZDIY straight adapter and it's much easier to install, it just needs a bit of trimming. To install this one, I threaded an M3 bolt on the far right end where the lock is, and threaded in a bunch of nuts. This supports the GPU vertically, otherwise it sags heavily. The ribbon itself is a bit stiff and it pushed the GPU outwards, so I installed the P3's vertical bracket. The screw bumps into the bracket as the cable pushes it outwards, keeping the GPU nice and straightThe cable itself worked no problem. My old riser was Gen 3 and it was a headache because my PC wouldn't post with it attached until I went into the BIOS and manually set my PCIe slot to Gen 3. With this new riser, it worked flawlessly with PCIe Gen 4. I'm running an EVGA 3070 Paired with an R7 7700x on a Strix B650a MoBo, for those interested.

Hola, digo parece porque no he podido co conectarlo al final. Y por lo tanto, no he podido comprobar ni el funcionamiento ni la velocidad.El problema como se ven las fotos es que la forma del conector impide que apoye en la base de la caja, y esos 5 mm de separación, además de impedir atornillar el soporte a la caja correctamente, hace que varíe la altura de la gráfica y no encaje bien en los alojamientos de la caja. yo lo he intentado colocar en una Abysm. no sé si en otras cajas encajaría mejor.

Super Kabel und qualitativ