OHLPRO3M VHB Sticky Adhesive Pads Replacement for Magnetic Phone Car Mount - Dashboard Sticker With 16MM Ball Diameter

Well made and strong as the clip that grips the blade of the vent is made of metal not plastic. The mechanism that tightens the mount holds well and rarely needs to be tightened. The magnet is strong and is illuminated to let you know it has power And holds steady even on rough and bumpy roads . Magnet Overall a great gadget for securing your devise.

Great vent clip, much better than the hook. But be careful you get the correct size ball as some phone holders have different sizes.

bought this to mount in new car but the backing came off the mount after only 2 days

I've bought 5 of these in total for my work's truck fleet and 1 from the original OHLPRO magsafe charger I purchased. Out of the 6, 2 of them had air pockets/bubbles in the adhesive before tearing off. I'm not sure if the actual 3M foam was bubbled up or not, but it did affect the ability for them to stick on. So expect about a third of these that you buy to end up as duds or defects especially if you have a strong magnet setup which will put stress on the adhesive.The 3M vHB material is great and mount is great on the ones that did work flawlessly. The adhesive cover may be a bit difficult to remove since there is no crease or handle. You will have to prep the surface super well, like clean with soap/wipes and make sure its completely dry. Any bit of dirt will ruin the adhesion and waste a mount, especially the ones that have slightly defective adhesives(they can still work and be salvaged if applied properly, i was able to save 1 out of the 2 and use it).My only gripe is that their warranty service on their webpage did not respond to my warranty request, so you are most likely out of luck with defectives and have to go through Amazon's return system.They make a great product, but seem to lack the customer service that ESR and other brands have.

works great with my charger that broke

Be careful about the ball size. As the description says, this has a 16mm ball, but many phone mounts use a 17mm ball socket. That was my problem with my wireless charging phone mount. I had to wrap this ball with a few layers of black electrical tape to get it to fit snugly in my phone mount, which was designed for a 17mm ball. Also, the description and photos show the clamps have a shiny metal reinforcement. But the one I received seems to be made completely of black plastic. No metal is visible on the clamps. It seems to hold pretty securely to my air vent and it seems sturdy enough. We'll see how sturdy it is over time without the metal reinforcement.

had to replace due to switching cars

Exactly what I needed. Super sturdy and holds well.