KATUR2pcs 50W 8ohm 3157 3047 3057 3457 3155 Led Load Resistors Fix LED Bulb Fast Hyper Flash for LED Turn Signal Light Blink or LED License Plate Light Error

I replaced the taillights on my 2016 F250 with LEDs and had the fast blink. This product installed in minutes with no wire soldering and worked fantastic. Highly recommended, well made.

Seems ok, worked with my rear LED turn signals, but will not work with switchback front LEDS. Comes from China so will take a bit to get them.

After only owning these 2 days one of the resistors went bad I was very un-pleased cause I read the reviews and read up on them as much as I could and I decided this was a good buy, upon receiving them and installing them I was happy with them they worked and all and were also a easy install that was until 2 days later one of them gave out after only owning them for 48 hours I would suggest to save your money and buy another type of resistors cause these here are a gamble and have left me very unsatisfied with my purchase.

Worked great on my 05 F150. Much cheaper than buying new aftermarket LED taillights. I guess one of the onboard resistors burnt out. 4 starts due to the "universal plug" not being a great fit for my lights. It holds itself in, but not nearly as well as the stock plugs.

I installed a set of LED tail lights over a year ago and they supposedly had resistors built in and I would get a hyper flash situation from time to time. So I looked around and found these plug and play resistors and decided to buy them and give them a try. After I installed them I have not had the hyper flash happen since

They work get and do what they are supposed to do but the middle metal pieces get so hot they may start melting what’s around it and I mean hot enough to probably give you 1st degree burn.

This fixed my turn signal problem at first my turn signals wouldn’t work with my headlights on and only one turn signal would work but when I installed these it completely solved the issue (try this before buying a turn signal switch) for Silverado owners

It already don't start well with the terminals not lining up with the bulb unless i bent the wires in the LED and even then, made it randomly flicker.But the nail in the coffin was the heat output on the resisters, only on for about 2 minutes to test polarity and i brushed my hand by accident for half a second and got burned, it felt hot enough to literally melt solder.It's implied that they want you to screw it to the body to distribute the heat, but that level of heat might as well be a fire hazard.

These got rid of my hyperflash and were super easy to install. Just like any resistor they get hot. Just make sure they are zip tied out of the way.

Even though the product didn't work for my vehicle, the sell did offer to compensate for the trouble, customer service is very good with them being understanding to the situation

I liked the plug and play idea to simplify it but the plug that goes in the headlight casing would not fit my 2018 Camry and I found it simpler and beater to put a resistor into the line. I will say they were great to refund me right away and very easy to return even without the package it came in.

U can get same set for half a price directly from China at AliExpress or Temu. Otherwise if in a hurry, buy here. They do the job on VW super sensitive electronics to trick it off for LED bulbs to work without annoying error popping up at the dashboard. And with VW there's no other way around but the resistors only.

Only one side consistently works, the other cuts in and out of operation