Acrylic Panel and Case DIY Set Kits Replacement for Game Joystick DIY Set Kits Replacement Game Machine Cabinet Controller DIY Kit

Great quality box and top, and the holes were cut perfectly for my buttons and joystick. Be aware the top buttons are a smaller size than the holes for the 6 control buttons. The suction cups did not include the J hooks that are shown in the picture. Instead screws were included that worked, but I’m worried they may loosen up over time. Recommended.

Great buy for those of us trying to build our own arcade/fight stick. I haven't the tools to build one from wood and haven't access to a 3D printer to print one so when I saw this I had to try it out. The materials are great quality plastic. All the hole are drilled properly and the screw hole line up perfectly! My only complaint thus far is I wish the provided screws receeded into the surface a little more. They provide very good flat/smooth surface screws so you won't find any discomfort, it will just make applying a skin or stickers a little rough and not smooth. Love this enclosure.... and if you are reading this just do it. It's totally worth it. It was also delivered before the projected date!

Incompleto

The top of the panel is a good acrylic quality, but the bottom box is made of a cheap plastic, also for my project do the joystick I wish the box was a little bit deep, but I added a 1/4" spacers between the top and the bottom box and is good to go, also the two buttonholes on the top are smaller than the fighting ones but they are easy to expand. Overall, I'm not disappointed with the product.

For a DIY arcade stick enclosure, this is pretty good at about the $25 price point. The included hardware is decent. Tip: the big screws are meant to be used with the suction cup feet. The other machine screws are for the joystick and the lid. Note the side with the USB cord exits and test your setup on a PC before you get it all together tight. The two smaller button holes are for 24 mm buttons. The six larger holes are for 30 mm buttons. Also, the protective sheathing is on both sides of the acrylic and meant to be taken off before mounting the buttons, etc. The recessed holes are on the top, so it is drilled for buttons on the right hand side. I used this with an old Qanba joystick that is JLF compatible. I also used Sanwa OBSF 30 and 24 sized buttons. They do snap in, but not as great as on a Qanba enclosure with the sheet metal backing. They work ok with the acrylic lid. I also used a Zero Delay USB controller. To be able to use my extra spare parts and build a second joystick for two player games with minimal cost, this is a good case.

Great little case. Built a few retro arcade sticks for my retro pi. Nice and big - plenty of room for wiring. I added some final decals to mine for a different look

it is great to have all the holes drilled already. Keep in mind that the two holes on the top are a different size, so you must get smaller buttons for these holes.

the tabs that hold the sticky feet in is just not in the box also the top holes are very small had to drill them out

Buen material, quedó muy bien

Only if, missing some instructions or user's manual